Design of Omnidirectional Mobile Platform Control System Based on STM32 CAN Bus Control
نویسندگان
چکیده
منابع مشابه
Design of the Distributed Control System Based on CAN Bus
The development trend of the aero-engine control system is the distributed control system (DCS), and the communication among devices is the key point and difficult point of DCS. In this article, the communication interface of CAN (Controller Area Network) bus is designed, the CAN communication technology among nodes is studied, the semi-physical platform of DCS is established, and the semi-phys...
متن کاملThe Control System Design of Middle-horsepower Electric Tractor Based on CAN Bus
This paper mainly for the research of the tractor horsepower electric control system, Its control system were designed based on ARM and CAN bus technology, The main node controller uses chip LPC2294, LPC2294 has a high speed of operation, high reliability advantages. The design of the hardware circuitry and the communication protocols in system. Tests showed that the system has high reliability...
متن کاملThe Control System Design of Hydraulic Hybrid Vehicle Based on CAN Bus
The hybrid vehicle is a new type of green and energy efficient vehicle. Hydraulic accumulator and variable pump/motor make up the break energy regeneration utilization system, which is the core of hydraulic auxiliary driving unit. The hybrid drive system is composed of hydraulic auxiliary driving unit and the original vehicle drive system. As it relates to the recovery of the braking energy and...
متن کاملDesign of Ethernet-CAN Protocol Conversion Module Based on STM32
CAN bus is ISO international standard serial communication protocol. It is one of the most widely used fieldbus in the world. It has become the standard bus of embedded industrial control LAN. Ethernet is the most common communication protocol standard that is applied in the existing LAN. Networked industrial control usually adopts fieldbus and Ethernet network, thus the protocol conversion pro...
متن کاملCAN-bus based rapid control prototyping system for education laboratories
The central element of the educational activities in mechatronics at SUPSI is the mechatronics laboratory, where students integrate the topics introduced by various courses. In order to increase the value of the laboratory to students and to reduce the cost of its creation and operation, a modular approach has been implemented, which relies on sensors and actuators communicating through the CAN...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Computer Science and Application
سال: 2017
ISSN: 2161-8801,2161-881X
DOI: 10.12677/csa.2017.79102