Designing a Reflecting Surface Array of Compliant Tubes
نویسندگان
چکیده
منابع مشابه
Designing Law-Compliant Software Requirements
New laws, such as HIPAA and SOX, are increasingly impacting the design of software systems, as business organisations strive to comply. This paper studies the problem of generating a set of requirements for a new system which comply with a given law. Specifically, the paper proposes a systematic process for generating law-compliant requirements by using a taxonomy of legal concepts and a set of...
متن کاملDesign and Fabrication of Pressure-Compensating Compliant Tubes
Different fabrication methods are evaluated for producing pressure-compensating tubes for use in low-pressure drip irrigation systems. Such devices would allow drip irrigation systems to operate at driving pressures much lower than those required by current available technology, allowing for cost and water savings in developing nations. Fabrication methods explored consist mainly of molding of ...
متن کاملdesigning a fast locking pll
a phase-locked loop (pll) based frequency synthesizer is an important circuit that is used in many applications, especially in communication systems such as ethernet receivers, disk drive read/write channels, digital mobile receivers, high-speed memory interfaces, system clock recovery and wireless communication system. other than requiring good signal purity such as low phase noise and low spu...
Computational studies of resonance wave pumping in compliant tubes
The valveless impedance pump is a simple design that allows the producion or amplification of a flow without the requirement for valves or impellers. It is based on fluid-filled flexible tubing, connected to tubing of different impedances. Pumping is achieved by a periodic excitation at an off-centre position relative to the tube ends. This paper presents a comprehensive study of the fluid and ...
متن کاملDesigning Distributed Compliant Mechanisms with Characteristic Stiffness
A novel method is proposed in this paper to address the cutting-edge problem of topology optimization of distributed compliant mechanisms, which requires the design to possess both large output displacements and evenly distributed compliance simultaneously. The design is represented by a level-set model that precisely specifies the distinct material regions and their sharp interfaces as well as...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Acoustical Society of America
سال: 1973
ISSN: 0001-4966
DOI: 10.1121/1.1982579