DEVELOPMENT OF A HIGH-PERFORMANCE BUILDING BLOCK USING POLYSTYRENE FOAM, ENGINEERED CARBON AND FOAMING FORM

Guar Foaming Albumin – A Foam Stabilizer

Improvement of sand using Portland cement and polystyrene foam container waste

The goal of this study was improvement of sandy soil using a combination of polystyrene foam container waste and Portland cement. For this purpose, Babolsar sand was used as the base soil. Strips of disposable polystyrene foam container waste in “chips” of 50 ´ 5 mm and 50 ´ 10 mm were added to the soil at 0.0%, 0.1%, 0.2% and 0.3% by weight along with 3% Portland cement at a relative density o...

development of different optical methods for determination of glucose using cadmium telluride quantum dots and silver nanoparticles

a simple, rapid and low-cost scanner spectroscopy method for the glucose determination by utilizing glucose oxidase and cdte/tga quantum dots as chromoionophore has been described. the detection was based on the combination of the glucose enzymatic reaction and the quenching effect of h2o2 on the cdte quantum dots (qds) photoluminescence.in this study glucose was determined by utilizing glucose...

iranian efl learners’ pragmatic development: a study of proficiency and textbook effect

در تحقیق حاضراین پرسش که آیا دانش کاربرد شناسی زبان آموزان ایرانی همگام با پیشرفت بسندگی زبانی آنها افزایش می یابد مورد مطالعه قرار گرفته و هم چنین به این پرسش که آیا زبان آموزان تعلیم دیده از طریق کتاب های تاپ ناچ و اینترچینج تفاوت معناداری از لحاظ سطح دانش کاربرد شناسی دلرند ، پاسخ داده شده است. در این تحقیق55 فراگیر زبان انگلیسی به عنوان زبان دوم ازطریق نمونه گیری در دسترس مورد مطالعه قرار گ...

Compressibility and Foaming behavior of steel slag/waste glass compositesby particle size distribution and foam agents

In present research, the foam glass-ceramic composites fabricated by window glass, steel slag and SiC, CaCO3 foaming agents were investigated by press–sintering method. The optimum sintering temperature was obtained at 1200°C with a 3-minutes holding time and 20°C/min heating rate. The optimum pressure level of 80 MPa for achieving the 70 % of relative density was selected. The effec...