Development of Cutting Process Simulater using FEM
نویسندگان
چکیده
منابع مشابه
the effect of using visual aids on the development of speech act of disagreement among iranian intermediate efl learners
abstract the present study tried to investigate the effect of visual aids (films) on the development of the speech act of disagreement among iranian efl intermediate learners. to this end, the researcher selected 40 homogeneous intermediate learners based on their scores on oxford placement test. .the subjects then divided into control group and experimental group. both classes were tested by ...
The Analysis and Simulation for Improved Cutting Process based on Finite Element Method (FEM) Analysis
The paper proposed the practical metal cutting process using FEM to simulate the traditional cutting process, the simulation and the analysis of the results are based on the support of DEFORM3D finite element software, and the characteristic between Galerkin Algorithm and FEM analysis is also analyzed. Then the paper processed the modeling procedure for FEM using Lagrange and Euler algorithm, t...
متن کاملdevelopment of different optical methods for determination of glucose using cadmium telluride quantum dots and silver nanoparticles
a simple, rapid and low-cost scanner spectroscopy method for the glucose determination by utilizing glucose oxidase and cdte/tga quantum dots as chromoionophore has been described. the detection was based on the combination of the glucose enzymatic reaction and the quenching effect of h2o2 on the cdte quantum dots (qds) photoluminescence.in this study glucose was determined by utilizing glucose...
Two-dimensional modeling of self-aligned silicide process with a general-purpose process simulater
INTRODUCTION In order to reduce source/drain resistance with shallower junction, self-aligned silicide(sa1icide) process was developed and is finding more applications to MOSFETs. Now, MOSFET process simulation including salicide process is a necessity. However, there have been few reports on salicide simulation mainly because the implement of 2D model is very difficult. We have developed a 2D ...
متن کاملModeling and simulation of forward Al extrusion process using FEM
The main objective of this paper is to study the effect of extrusion parameters (extrusion stresses and temperature) and die geometry, i.e. extrusion radius, on the extruded aluminum quality using FEM Simulation Technique. For this purpose, the general FEA Software ABAQUS was used to set up the finite element model of the warm aluminum extrusion in two dimensions (2D). Aluminum alloy Al-2014 wa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering, Contributed Papers
سال: 2005
ISSN: 1881-8722,1348-8724
DOI: 10.2493/jspe.71.115