Development of Eddy Current Testing System for Complicated-Shaped Components
نویسندگان
چکیده
منابع مشابه
Development of Pulsed Eddy Current Testing System for Wall Thinning through Insulation with Ferromagnetic Cladding
Corrosion is one of the important factors in equipment failures. Wall thinning can be used to evaluate corrosion conditions. However, most of equipments are coated with insulations in order to elevate the energy efficiency. Pulsed eddy current (PEC) testing technique can be used to measure wall thinning through insulation. But when the insulation outside is wrapped with galvanized steel, PEC si...
متن کاملEddy Current Tomography for Nondestructive Testing
The paper presents an eddy current tomography setup with high spatial resolution and high accuracy of measurements of signal on detection coil. In proposed solution both amplitude as well as phase shift are measured, which gives the possibility of calculation of spatial distribution of both permeability and resistivity of tested element. As a result, presented setup creates possibility of effec...
متن کاملHigh Frequency Eddy Current Testing
This paper presents a nondestructive, high frequency electromagnetic evaluation method which can be applied for the examination of periodic conductive strips or conductive fibers using the evanescent modes generated in slits or in dielectric insulation between conductive fibers. For the detection of evanescent waves we propose the use of lenses with metamaterials, both conical Swiss roll type a...
متن کاملApplication of Lorentz force eddy current testing and eddy current testing on moving nonmagnetic conductors
Lorentz force eddy current testing is a novel nondestructive testing technique which can be applied preferably to the identification of internal defects in non-ferromagnetic moving conductors. This paper describes the comparison of this new technique with well-known eddy current testing. Measurements and numerical simulations have been done for both techniques for artificial subsurface defects ...
متن کاملDesign of Nondestructive System for Hardness of Carbonitrided Steel Parts Using Eddy Current Testing Method: Case study on the Tappet Parts
In this paper, a non-destructive eddy current test system was designed to evaluate the surface hardness of the carbonitrided steel parts. For this purpose, various samples of the tappet were used after the surface hardening and grinding operations as control samples and, if necessary, were subjected to destructive and non-destructive tests. Microstructural studies were performed with a microsco...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Atomic Energy Society of Japan
سال: 2008
ISSN: 1347-2879,2186-2931
DOI: 10.3327/taesj.j07.013