Development of Fiber Laser System for Material Processing
نویسندگان
چکیده
منابع مشابه
simulation and design of electronic processing circuit for restaurants e-procurement system
the poor orientation of the restaurants toward the information technology has yet many unsolved issues in regards to the customers. one of these problems which lead the appeal list of later, and have a negative impact on the prestige of the restaurant is the case when the later does not respond on time to the customers’ needs, and which causes their dissatisfaction. this issue is really sensiti...
15 صفحه اولFiber laser development for LISA
We have developed a linearly-polarized Ytterbium-doped fiber ring laser with single longitudinal-mode output at 1064nm for LISA and other space applications. Single longitudinalmode selection was achieved by using a fiber Bragg grating (FBG) and a fiber Fabry-Perot (FFP). The FFP also serves as a frequency-reference within our ring laser. Our laser exhibits comparable low frequency and intensit...
متن کاملAdaptive Optics Control for Laser Material Processing
An adaptive optics system is used for correcting tip-tilt disturbances in an experimental laser material processing setup. The proposed tip-tilt controller is based on PI-controllers that are fed with disturbance estimates from a Kalmanfilter. In addition, delays due to wavefront computation in the wavefront sensor and from data transmission are taken into account in the loop-shaping design. La...
متن کاملTubular filamentation for laser material processing
An open challenge in the important field of femtosecond laser material processing is the controlled internal structuring of dielectric materials. Although the availability of high energy high repetition rate femtosecond lasers has led to many advances in this field, writing structures within transparent dielectrics at intensities exceeding 10(13) W/cm(2) has remained difficult as it is associat...
متن کاملNonminimum Phase Behavior of Laser Material Processing
Optical sensors are increasingly applied in laser material processing to monitor and control the lasermaterial interaction zone. Dynamic models, relating the sensor signals (e.g. as temperature or molten area) to the process inputs (e.g. laser power or beam velocity), provide the basis for the design and tuning of a feedback controller. These models can show nonminimum phase (NMP) behavior. Thi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Review of Laser Engineering
سال: 2007
ISSN: 0387-0200,1349-6603
DOI: 10.2184/lsj.35.764