DEVELOPMENT OF HIGH DAMPING FERRITE RUBBER BEARING
نویسندگان
چکیده
منابع مشابه
Development of a Robot Arm System Using High-damping Pneumatic Artificial Rubber Muscle
Introduction Pneumatic artificial rubber muscle (PARM) is a pneumatically driven actuator that provides mechanical effects similar in principle to those of muscle contraction. PARM is a novel actuator that has a high weight-power ratio and maximum contraction over the nominal length is 20%. As shown in Figure 1 , PARM is composed of a rubber tube impregnated with fibers. Teleoperation of pneuma...
متن کاملThe Effect of Damping and Stiffness of Bearing on the Natural Frequencies of Rotor-bearing System
In this paper, the effectiveness of stiffness and damping of bearing is investigated on the natural frequencies of the rotor-bearing system. The rotor-bearing system consists of a shaft, two bearings and a disk between two bearings. Parallel spring-damper in horizental and vertical directions is considered for modeling the stiffness and damping of bearings. The gyroscopic effect is also conside...
متن کاملSynthesis and Characterization of Carbon-Bearing Ni(II) Ferrite (CBNF)
carbon-bearing Ni(II)-femte (CBNF) was prepared by repeated decomposition of CO2 on Hz-reduced Ni(II> femte. The material was also characterized by Mossbauer spectra, XRD and chemical analysis. A peculiar amorphous surface layer composed of carbon, divalent transition metals and oxide ions (CIO layer) was found to be synthesized on the surface of the CBNF. Deposited carbon on the CBNF was chara...
متن کاملH2 Evolution Reactivity of Carbon-Bearing Ni(II) Ferrite (CBNF)
Two-step water-splitting with a carbon-bearing Ni(II) ferrite (CBNF) at 300°C has been studied. The chemical analysis of the solid phase showed that the CBNF was gradually oxidized during repeated water splitting, but the evolved H2 amount is 1.5-2 times larger than that expected &om the oxidation of the CBNF. Following two types of hydrogen evolution reactions are considered to be participated...
متن کاملA modular bearing with internal piezoshunt damping
When a piezoelectric transducer is incorporated in a mechanical structure, it is possible to damp the structural vibrations of the base structure by passive energy dissipation in the electrical domain [1]. Due to the strong electromechanical coupling in piezoelectric elements, the mechanical energy can be efficiently converted to electrical energy. By shunting the piezoelectric element to a pas...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Doboku Gakkai Ronbunshu
سال: 1991
ISSN: 0289-7806,1882-7187
DOI: 10.2208/jscej.1991.433_101