Development of High Strength Composite Parts by Direct Injection Molding

نویسندگان

چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Dynamic of Taking out Molding Parts at Injection Molding

E. Ragan, J. Dobránsky, P. Baron, M. Kočiško, J. Svetlík, Technical University in Košice, Slovakia Most plastic parts used in automobile production are manufactured by injection molding. Their quality depends also on taking out molding and on the manipulators for it. Task of this contribution is to theoretically describe a transport of molding at taking out after injection molding in relation o...

متن کامل

Investigation of effective parameters on fabrication of alumina parts by low pressure injection molding (LPIM) method

Low pressure injection molding (LPIM) method in this paper is investigated as a method of forming alumina parts. This is one of the methods of making engineering ceramics with complex shapes and high dimensional accuracy. In this method, a binder system (paraffin wax + carnuba wax) was used as a plastic agent for easy formation of alumina particles. Different parameters such as feedstock temper...

متن کامل

Outstanding features of powder injection molding for micro parts manufacturing

When powder injection molding first appeared on the market, it was very well received for the potential it offered. However, the market did not grow as expected at that time. In recent years, the perseverance of manufacturers in this field has borne fruit, and today, the market is about 10 billion yen. However, looking at the market, one is still painfully aware of how low its recognition remai...

متن کامل

Optimization of the injection molding process of Derlin 500 composite using ANOVA and grey relational analysis

Warpage and shrinkage control are important factors in proving the quality of thin-wall parts in injection modeling process. In the present paper, grey relational analysis was used in order to optimize these two parameters in manufacturing plastic bush of articulated garden tractor. The material used in the plastic bush is Derlin 500. The input parameters in the process were selected according ...

متن کامل

Precision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING

1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Seikei-Kakou

سال: 1994

ISSN: 1883-7417,0915-4027

DOI: 10.4325/seikeikakou.6.559