Development of the ship hull assembly sub-process

Objective: The development of the ship hull assembly pro-cess is possible by changing method basic parts at building site, which would shorten duration process and lead to cost reduction. One pos-sibilities increase dimensions mass units, as well crane capacity site. Methods: Ship methods involving sections, blocks modules are used in phase. In world’s best shipyards, ships built from or modules, much equipment in-stalled. This paper uses finite element (FEM) for structural analysis, its results serve define opti-mal technological instructions vertical transport structure blocks. Results: sub-pro-cess can be achieved using block meth-od instead section method. For presented this paper, a transported site was increased 3 times, so number units reduced 65%. reduces trans-port activities on shortens dura-tion 20%. shows that strengthening with temporary stiffen-ers necessary safe transport. It optimize their layout analysis. Conclusion: numerical methods, software packages, computers allow wider use analysis solving engineering problems shipbuilding technology. simulation realistic sit-uations, wide range analyses large become possible, they raise level knowledge enable better decision-making pro-duction process.