Development of Thin Film Fabrication Using Magnetron Sputtering

Fabrication of InGaN thin-film transistors using pulsed sputtering deposition

We report the first demonstration of operational InGaN-based thin-film transistors (TFTs) on glass substrates. The key to our success was coating the glass substrate with a thin amorphous layer of HfO2, which enabled a highly c-axis-oriented growth of InGaN films using pulsed sputtering deposition. The electrical characteristics of the thin films were controlled easily by varying their In conte...

Thin-film TiPbO3 varistors obtained by two-source magnetron sputtering

An introduction to thin film processing using high-power impulse magnetron sputtering

Film thickness distribution in magnetron sputtering

Of crucial importance to the thin film process engineer is an understanding of the parameters which affect the film thickness distributions which may be obtained from magnetron sources. This paper describes how variations in source design, target erosion and source-to-substrate distance affect observed uniformities from a magnetron source. A simple method of simulating magnetron sources using t...

The Effect of Substrate on Structural and Electrical Properties of Cu3N Thin Film by DC Reactive Magnetron Sputtering

The aim of this paper is to study the effect of substrate on the Cu3N thin films. At first Cu3N thin films are prepared using DC magnetron sputtering system. Then structural properties, surface roughness, and electrical resistance are studied using X-ray diffraction (XRD), the atomic force microscope (AFM) and four-point probe techniques respectively. Finally, the results are investigated and c...