Di-directional Solidification of Pure Aluminium and Al-Cu Alloy Ingots
نویسندگان
چکیده
منابع مشابه
HOT CRACK FORMATION IN PURE CU AND CU-30%ZN ALLOY DURING IN SITU SOLIDIFICATION
The hot cracking susceptibility can be determined by establishing the transition temperature between brittle and ductile fracture at high temperature tensile testing of in situ solidified samples. High temperature tensile properties were determined for commercial cathodic pure Cu and Cu- 30%Zn alloy. The transition temperatures for pure Cu and Cu-30%Zn were evaluated from ultimate tensile stres...
متن کاملUpward and downward unsteady-state directional solidification of a hypoeutectic Al-3wt.%Mg alloy
Solidification thermal parameters, such as growth rate, cooling rate and dendrite arm spacing ( ), have been measured in a hypoeutectic Al-Mg alloy directionally solidified under upward and downward transient heat flow conditions. The experimental setup used in this work consists of a water-cooled mould with heat being extracted from the bottom or the top, promoting upward and downward directio...
متن کامل' * , sy Solidification Behavior and Structure of AI - Cu Alloy Welds
The microsegregation behavior of electron beam (EB, and gas tungsten arc (GTA) welds of Al-Cu alloys covering a range from 0.19 to 7.74 wt% Cu were characterized for dendrite core concentrations and fraction eutectic solidification. Although a single weld speed of 12.7 mm/sec was used, some differences were observed in the segregation behavior of the two weld types. The microsegregation behavio...
متن کاملComprehensive Numerical Simulation of Filling and Solidification of Steel Ingots
In this paper, a complete three-dimensional numerical model of mold filling and solidification of steel ingots is presented. The risk of powder entrapment and defects formation during filling is analyzed in detail, demonstrating the importance of using a comprehensive geometry, with trumpet and runner, compared to conventional simplified models. By using a case study, it was shown that the simp...
متن کاملPreparation of ingots of uranium-niobium alloy
A study was made of the preparation of a uranium 10 w/o niobium alloy by the bomb reduction of a suitable form of niobium and uranium tetrafluoride with calcium. A compound with a probable formula of Na2NbOF5 proved to be most satisfactory as the source of niobium. High yields and good metal-slag separations were obtained. Chemical analysis and density determinations showed the composition to b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1972
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.36.4_316