Direct reduction processes for titanium oxide in molten salt
نویسندگان
چکیده
منابع مشابه
Direct electrochemical reduction of titanium-bearing compounds to titanium-silicon alloys in molten calcium chloride
Titanium-silicon alloys have been electrochemically extracted from the multi-component titanium compounds in molten calcium chloride electrolyte. Sintered pressed pellets of titanium-bearing compounds served as the cathode, and the electrochemical experiments were systematically carried out at 900 °C, 3.1 V and 1000 °C, 3.8 V using a graphite-based anode and an improved inert-oxygen-ion-conduct...
متن کاملDirect oxygen removal technique for recycling titanium using molten MgCl2 salt.
Deoxidation of Ti, or direct removal of O dissolved in metallic Ti, is known to be extremely difficult when Mg is used as the deoxidizing agent. This difficulty arises because the chemical potential of O2, pO2, under Mg/MgO equilibrium is high (approximately 10(-41) atm at 1200 K) and is equivalent to that of Ti containing ∼2 mass% O at 1200 K. Therefore, when deoxidizing Ti to the commercial l...
متن کاملMolten-salt Reactor Chemistry
This document summarizes the large program of chemical research and development which led to selection of fuel and coolant compositions for the Molten-Salt Reactor Experiment (MSRE) and for subsequent reactors of this type. Chemical behavior of the LiF-BeFrZrFrUF4 fuel mixture and behavior of fission products during power operation of MSRE are presented. A discussion of the chemical reactions w...
متن کاملThe effects of different molten salt composition on morphology and purity of ZrB2 powder obtained via direct molten salt reaction method
Zirconium Diboride (ZrB2) powder was synthesized at low temperature via a Direct Molten Salt Reaction (DMSR) method. The influence of different salt compositions including eutectic mixture of (KF-NaF), (KF-KCl) and (KCl-NaCl) on the morphology and purity of the reaction products was studied. The obtained samples were characterized by scanning electron microscopy (SEM) and X-ray diffraction (XRD...
متن کاملThe Influence of Fluoride Anion on the Equilibrium between Titanium Ions and Electrodeposition of Titanium in Molten Fluoride–Chloride Salt
NaClKClTiClx was prepared via using titanium sponge to reduce titanium tetrachloride in a NaClKCl melt under a negative pressure at 1023K. The relationship between titanium valence states and [F]/[Ti] molar ratios was investigated with successive adding potassium fluoride in the pre-prepared NaClKClTiClx. It was found that the average valence of titanium ions tended to be stable around 3.0...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOM
سال: 2007
ISSN: 1047-4838,1543-1851
DOI: 10.1007/s11837-007-0014-7