Direct spinning and densification method for high-performance carbon nanotube fibers
نویسندگان
چکیده
منابع مشابه
Thermal conductivity of high performance carbon nanotube yarn-like fibers
Articles you may be interested in Synergistic effect of self-assembled carboxylic acid-functionalized carbon nanotubes and carbon fiber for improved electro-activated polymeric shape-memory nanocomposite Appl. Filler geometry and interface resistance of carbon nanofibres: Key parameters in thermally conductive polymer composites Appl. Effective multifunctionality of poly(p-phenylene sulfide) na...
متن کاملEffects of surfactants on spinning carbon nanotube fibers by an electrophoretic method.
Thin fibers were spun from a colloidal solution of single-walled carbon nanotubes (SWNTs) using an electrophoretic method. Sodium dodecylbenzenesulfonate (NaDDBS) was chosen as a surfactant and showed good performance owing to its special chemical structure. The highest spinning velocity reached 0.5 mm s-1. The resulting SWNT fibers had a tensile strength of 400 MPa and a conductivity of 355 S ...
متن کاملNanotube Composite Carbon Fibers
The mechanical properties of materials in small rod-shaped form are of considerable technological interest since, due to their shape and size, they can exhibit appreciably greater strength relative to corresponding macroscopic forms. For example, the mechanical strength of silicon carbide whiskers systematically increases with decreasing whisker diameter over the 100 to 1 micron range. This phe...
متن کاملStrong carbon-nanotube fibers spun from long carbon-nanotube arrays.
The superior mechanical properties of carbon nanotubes (CNTs) mean they have been regarded as a new material with the potential to revolutionize and enable many advanced technologies. CNTs have extremely high tensile strength ( 150 GPa), high modulus ( 1 TPa), large aspect ratio, low density, good chemical and environmental stability, and high thermal and electrical conductivity. These superior...
متن کاملFabrication, densification, and replica molding of 3D carbon nanotube microstructures.
The introduction of new materials and processes to microfabrication has, in large part, enabled many important advances in microsystems, lab-on-a-chip devices, and their applications. In particular, capabilities for cost-effective fabrication of polymer microstructures were transformed by the advent of soft lithography and other micromolding techniques (1, 2), and this led a revolution in appl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nature Communications
سال: 2019
ISSN: 2041-1723
DOI: 10.1038/s41467-019-10998-0