Dry Sliding Wear Behavior of Aluminium Matrix Composite Using Red Mud an Industrial Waste
نویسندگان
چکیده
منابع مشابه
Wear Behavior of Aluminium Metal Matrix Composite Prepared from Industrial Waste
With an increase in the population and industrialization, a lot of valuable natural resources are depleted to prepare and manufacture products. However industrialization on the other hand has waste disposal issues, causing dust and environmental pollution. In this work, Aluminium Metal Matrix Composite is prepared by reinforcing 10 wt% and 20 wt% of wet grinder stone dust particles an industria...
متن کاملDry Sliding Wear and Mechanical Behavior of Aluminium / Fly ash / Graphite Hybrid Metal Matrix Composite Using Taguchi Method
The experimental investigation of hybrid metal matrix composites with fly ash and graphite reinforced aluminium alloy (Al 6061) composites samples, processed by stir casting route are reported. The aluminium alloy was reinforced with 3 wt.%, 6 wt.%, 9 wt.% fly ash and fixed 3 wt.% of graphite to mixture the hybrid composite. Hardness of the hybrid composite were tested it was found that when th...
متن کاملMicrostructure and Dry-Sliding Wear Behavior of B4C Ceramic Particulate Reinforced Al 5083 Matrix Composite
B4C ceramic particulate–reinforced Al 5083 matrix composite with various B4C content was fabricated successfully via hot-press sintering under Argon atmosphere. B4C particles presented relative high wettability, bonding strength and symmetrical distribution in the Al 5083 matrix. The hardness value, friction coefficient and wear resistance of the composite were higher than those of the Al 5083 ...
متن کاملDry Sliding Wear Behavior of Epoxy-Rubber Dust Composites
Composite pins of rubber dust collected from tyre retreading centres of trucks, cars and buses etc.and epoxy with weight percentages of 10. 15, and 20 % of rubber (weight fractions of 9, 13 and 17 % respectively) have been prepared in house with the help of a split wooden mould. The pins were tested in a pin-on-disc wear monitor to determine the co-efficient of friction and weight losses with v...
متن کاملPositron Lifetime Measurements of Subsurface Region in Aluminium Alloy and Aluminium Alloy Composite after Dry Sliding
This paper presents positron lifetime studies of the subsurface region of AK12 aluminium alloy and Al2O3-particle-reinforced AK12 aluminium alloy composite after sliding against steel in the pin-on-disc machine. The defect depth profile detected in the AK12 alloy extended up to 300 μm but for the composite AK12 the range of this profile was significantly shortened to less than ∼ 90 μm. The posi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Research Journal of Pure and Applied Chemistry
سال: 2013
ISSN: 2231-3443
DOI: 10.9734/irjpac/2014/2906