DSP implementation of fuzzy logic-based voltage stabilization control
نویسندگان
چکیده
منابع مشابه
Design and Implementation of Fuzzy Logic Based Voltage Control of A 3- Phase Power Converter
This project presents the operation of a distributed generation (DG) system driven by a dcdc step-up converter and a dc-ac voltage source inverter (VSI) interfaced with the power grid by Fuzzy Controller. To create a stable mode when different kinds of loads are connected locally or when working under contingency, the step-up converter must regulate the dc link voltage, allowing the VSI to stab...
متن کاملDsp-based Fast Fuzzy Logic Controllers
This paper presents an approach to implementing a fast FLC on a DSP in order to achieve high speed operation with a small sampling interval. This approach uses some specific techniques for hardware-software co-design, where hardware-specific properties of DSP architecture are utilized to reduce the number of computations required in software. The DSP approach is cost-effective and useful for pr...
متن کاملFuzzy Logic Based Constant Voltage Control of Fuel Cells
Proton exchange membrane fuel cells have been receiving more and more attention these recent years. Maintaining a fuel cell system in correct operating conditions requires good controller. Based on the mathematical model of proton exchange membrane fuel cells described in this paper, the fuzzy logic controllers was designed for the proton exchange membrane fuel cell to make it possible to outpu...
متن کاملSecondary voltage control system based on fuzzy logic
This paper discusses the problem of secondary voltage control in power systems. This problem is of deep interest for researchers and engineers, since it imposes serious restrictions to system’s operators. In general, this problem is resolved by selecting pilot buses representative of a region. Instead, in this paper, modal analysis is used to identify a coherent group of buses to be monitored. ...
متن کاملDSP implementation of output voltage reconstruction in CSI-based converters
Current-source-inverter-based uninterruptible power supplies and V=f -controlled induction motor drives require sensing of two or more load voltages in addition to the dc voltage sensors used for protection purposes. This paper proposes a digital-signal-processor (DSP)-based load voltage control scheme that requires only information provided by the dc-bus voltage sensor. Load voltage estimation...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ERJ. Engineering Research Journal
سال: 2002
ISSN: 1110-1180
DOI: 10.21608/erjm.2002.70917