Ductile cooling phase change material

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Off - Peak Cooling Using Phase Change Material

The electric utilities in the United States are faced with continued rapid growth in electrical demand. The traditional response to growth in demand has been the expansion of generating capacity. However , economic, environmental, and scheduling constraints will combine to make adequate expansion difficult, if not impossible, in the 1980's. This thesis examines load management as an alternative...

متن کامل

Application of Phase Change Material (PCM) for Cooling Load Reduction in Lightweight and Heavyweight Buildings: Case Study of a High Cooling Load Region of Iran

The application of phase change material (PCM) for energy conservation purposes in the residential buildings was investigated in the present study. Two types of building in terms of materials as the lightweight building (LWB) and heavyweight building (HWB) located in a high cooling load demanding region of Iran were considered for the study. Different types of PCM from organic and inorganic cat...

متن کامل

Transient cooling of electronics using phase change material (PCM)-based heat sinks

Use of a phase change material (PCM)-based heat sink in transient thermal management of plastic quad flat package (QFP) electronic devices was investigated experimentally and numerically. Results show that increased power inputs enhance the melting rate as well as the thermal performance of the PCM-based heat sinks until the PCM is fully melted. A three-dimensional computational fluid dynamics ...

متن کامل

Microencapsulation of Butyl Stearate as Phase Change Material by Melamine Formaldehyde Shell for Thermal Energy Storage

Butyl stearate as a phase change material was microencapsulated within melamine-formaldehyde resin using emulsion polymerization. Morphology and thermal specification of produced microcapsules were studied by Fourier transform infrared spectroscopy, FT-IR, scanning electron microscopy, SEM, and Differential scanning calorimetry analysis, DSC. FT-IR spectra validated the existence of the butyl s...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Nanoscale Advances

سال: 2020

ISSN: 2516-0230

DOI: 10.1039/d0na00465k