Duty ratio control ofthree port isolated bidirectional asymmetrical triple active bridge DC-DC converter
نویسندگان
چکیده
Multiport converters are used in interfacing of distributed energy sources with grid/load. Isolated needed applications where converter gain is high and there a requirement isolation. Dual transformer asymmetric triple active bridge offers the advantage reduced circulating current. However, operating range low for variation load source voltage. In this paper duty ratio modulation technique proposed to regulate voltage control power flow both directions. As result new gating scheme, switches operate ZVS, irrespective variations The designed ensure switch utilization. validatedthrough simulation 1kW three port DC-DC converter. It was observerd that regulated wide voltages. single input dual output mode also verified.
منابع مشابه
Operation , design and control of dual H - bridge - based isolated bidirectional DC – DC converter
The operation, design and control of an isolated bidirectional DC–DC converter for hybrid electric vehicle energy management applications are discussed. Different operation modes and boundary conditions are distinguished by phase-shift angle and load conditions. The absolute and relative output voltage ripple was derived. The dead-band effect and safe operational area are further investigated. ...
متن کاملHigh-conversion-ratio Bidirectional Dc–dc Converter with Coupled Inductor
Abstract—In this paper, a high-conversion-ratio bidirectional dc–dc converter with coupled inductor is proposed. In the boost mode, two capacitors are parallel charged and series discharged by the coupled inductor. Thus, high step-up voltage gain can be achieved with an appropriate duty ratio. The voltage stress on the main switch is reduced by a passive clamp circuit. Therefore, the low resist...
متن کاملHigh-Conversion-Ratio Bidirectional DC-DC Converter with Ultra Capacitors
In this paper, a high-conversion-ratio bidirectional dc–dc converter with coupled inductor is proposed. In the boost mode, two capacitors are parallel charged and series discharged by the coupled inductor. Thus, high step-up voltage gain can be achieved with an appropriate duty ratio. The voltage stress on the main switch is reduced by a passive clamp circuit. Therefore, the low resistance RDS(...
متن کاملA High-Efficiency Isolated-Type Three-Port Bidirectional DC/DC Converter for Photovoltaic Systems
This paper proposes a novel high-efficiency isolated three-port bidirectional DC/DC device for photovoltaic (PV) systems. The device contains a high step-up converter for PV modules to supply power to the DC bus, and a bidirectional charge/discharge control circuit for the battery with an improved boost-flyback converter. When the PV modules supply sufficient energy, their output can be stepped...
متن کاملA High-Efficiency Isolated LCLC Multi-Resonant Three-Port Bidirectional DC-DC Converter
In this paper, an isolated multi-resonant three-port bidirectional direct current-direct current (DC-DC) converter is proposed, which is composed of three full bridges, two inductor-capacitorinductor-capacitor (LCLC) multi-resonant tanks and a three-winding transformer. The phase shift control method is employed to manage the power transmission among three ports. Relying on the appropriate para...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Power Electronics and Drive Systems
سال: 2021
ISSN: ['2722-2578', '2722-256X']
DOI: https://doi.org/10.11591/ijpeds.v12.i2.pp943-956