Dynamic Analysis of Extendable Hybrid Voltage Lift DC–DC Converter for DC Microgrid

This paper proposes a novel non-isolated high voltage gain dc–dc converter with boost2 (B2) technique. The derived single-switch hybrid voltage-lift topology generates higher conversion ratio less component counts than traditional converters. Furthermore, to show its superiority, the proposed is compared other recent converters in terms of number power components such as inductors, capacitors, diodes, and switches. Moreover, stress across switch output voltage, which results using low-rated reducing cost. steady-state analysis carried out operating modes continuous discontinuous conduction modes. critical inductance for design considerations. Compared step-up converters, stresses diodes are highly reduced. related addition an expander cell performed concerning boundary conditions. An efficiency model loss calculation presented. reliability military handbook determine failure rate converter’s components. Finally, simulation 50 W prototype experimental validation prove strength topology.