Dynamic Behavior of a Penicilin Cultivator
نویسندگان
چکیده
منابع مشابه
dynamic coloring of graph
در این پایان نامه رنگ آمیزی دینامیکی یک گراف را بیان و مطالعه می کنیم. یک –kرنگ آمیزی سره ی رأسی گراف g را رنگ آمیزی دینامیکی می نامند اگر در همسایه های هر رأس v?v(g) با درجه ی حداقل 2، حداقل 2 رنگ متفاوت ظاهر شوند. کوچکترین عدد صحیح k، به طوری که g دارای –kرنگ آمیزی دینامیکی باشد را عدد رنگی دینامیکی g می نامند و آنرا با نماد ?_2 (g) نمایش می دهند. مونت گمری حدس زده است که تمام گراف های منتظم ...
15 صفحه اولdesign of a new cultivator (part 2: kinematic and dynamic analysis)
a new mechanical cultivator was proposed for mechanical weeding in part one. the precise point method was used to geometric design of this new cultivator. the aim of this research is selecting the suitable mechanism of the studied mechanisms in part one. the velocity and acceleration of links (kinematic) is the base of dynamic analysis of the systems. the variation of velocity, acceleration and...
متن کاملPerformance Evaluation of Draught Animal Power Cultivator
Prefix 10.18034 This performance evaluation was conducted to pave the way for making use of Draught Animal Power Cultivator and cosequently possibilities of adaptation in our local condition between 2010 and 2011 in the Jimma zone two districts of southwestern Ethiopia on the farmers’ field to evaluate energy requirement. To improve weed management at the small holder farmers level, animal-draw...
متن کاملDynamic Behavior Analysis of a Geometrically Nonlinear Plate Subjected to a Moving Load
In this paper, the nonlinear dynamical behavior of an isotropic rectangular plate, simply supported on all edges under influence of a moving mass and as well as an equivalent concentrated force is studied. The governing nonlinear coupled PDEs of motion are derived by energy method using Hamilton’s principle based on the large deflection theory in conjuncture with the von-Karman strain-displacem...
متن کاملDynamic Behavior Analysis of a Planar Four-bar Linkage with Multiple Clearances Joint
In practice, clearances in the joints are inevitable due to tolerances, and defects arising from design and manufacturing. In the presence of clearance at a joint, a mechanism gains some additional, uncontrollable degrees of freedom which are the source of error. Moreover, joints undergo wear and backlashes and so cannot be used in precision mechanisms. In this study, the dynamic behaviour of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1952
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.18.70_52