Dynamic Mechanical Analysis and Three-Body Abrasive Wear Behaviour of Thermoplastic Copolyester Elastomer Composites
نویسندگان
چکیده
منابع مشابه
Two-body and three-body abrasive wear behaviour of polyaryletherketone composites
Single and multipass two-body and three-body abrasive wear behaviour of various polyaryletherketone composites have been carried out by using a pin-on-disc machine and a rubber wheel abrasion test (RWAT) rig. Abrasive wear studies were conducted under different loads and sliding distances. Comparative wear performance of all the composites at different loads shows that specific wear rate (Ko) o...
متن کاملThree-body wear of different composites resins
Introduction: Low resistance of composite resins to abrasion is a primary concern in the application of these materials for posterior restorations which are prone to high occlusal loads. This study compared the wear resistance of three types of composites. Methods: In this laboratory experiment, five specimens of each of the three types of composites (z250, Heliomolar, Opallis) were prepared...
متن کاملAbrasive Wear in Three-phase Waste-based Polymeric Particle Composites
Original scientific paper The experiment centres on two and three body abrasion in three-phase waste-based composite systems. The composite systems abrasion resistance is defined not only by the physical-mechanical relationships of the separate phases of the composite, but also by the mutual interaction of the phases and on the matrix-filler interface. To describe the composite system abrasion ...
متن کاملMechanical, Electrical and Electro-Mechanical Properties of Thermoplastic Elastomer Styrene-Butadiene-Styrene/Multiwall Carbon Nanotubes Composites
Composites of styrene-butadiene-styrene (SBS) block copolymer with multiwall carbon nanotubes (MWCNT) were processed by solution casting in order to investigate the influence of filler content, the different ratio of styrene/butadiene in the copolymer and the architecture of the SBS matrix on the electrical, mechanical and electro-mechanical properties of the composites. It was found that fille...
متن کاملParametric optimization of Three-Body Abrasive Wear Behavior of Bidirectional and Short Kevlar Fiber Reinforced Epoxy Composites
In this article, the mechanical and three body abrasive wear behavior of Bidirectional and short Kevlar fiber reinforced epoxy composites at five different fiber loading (10wt%, 20wt%, 30wt%, 40wt% and 50wt%) have been evaluated. The mechanical properties i.e. tensile strength, flexural strength, inter-laminar-shear strength, and impact strength are performed to notice the behavior of mechanica...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Tribology
سال: 2014
ISSN: 1687-5915,1687-5923
DOI: 10.1155/2014/210187