Effect of anodic/cathodic area ratio on pitting attacks for aluminum alloy 5052 in AlCl3 solution.
نویسندگان
چکیده
منابع مشابه
The Inhibition of Sodium Oleate for Pitting Corrosion of Aluminum Alloy 2024 in 0.1 mol L-1 NaCl Solution
The inhibition mechanism of sodium oleate (C17H33COONa) for pitting corrosion of aluminum alloy (AA) 2024 in 0.1 mol L NaCl solution was investigated using potentiodynamic polarization, electrochemical impedance spectroscopy (EIS), scanning electron microscopy with energy dispersive spectrometer (SEM-EDS) and X-ray photoelectron spectroscopy (XPS). C17H33COONa showed good inhibition effect on u...
متن کاملDirect Electrosynthesis of Polyaniline–Fe2O3 Nanocomposite Coating on Aluminum Alloy 5052 and Its Corrosion Protection Performance
The synthesis of polyaniline- Fe2O3 nanocomposite coating on aluminum Alloy 5052 (AA5052) surface has been investigated by using the galvanostatic method. The anticorrosion performance of polyaniline-Fe2O3 coating was investigated in 3.5% NaCl solution by the open- circuit potential (OCP), Tafel polarization technique and Electrochemical Impedance Spectroscopy (EIS). The corrosion rate of polya...
متن کاملLow temperature deformation behavior of an electromagnetically bulged 5052 aluminum alloy
The fundamental understanding of the deformation behavior of electromagnetically formed metallic components under extreme conditions is important. Here, the effect of low temperature on the deformation behavior of an electromagnetically-bulged 5052 aluminum alloy was investigated through uniaxial tension. We found that the Portevin-Le Chatelier Effect, designated by the serrated characteristic ...
متن کاملthe washback effect of discretepoint vs. integrative tests on the retention of content in knowledge tests
در این پایان نامه تاثیر دو نوع تست جزیی نگر و کلی نگر بر به یادسپاری محتوا ارزیابی شده که نتایج نشان دهندهکارایی تستهای کلی نگر بیشتر از سایر آزمونها است
15 صفحه اولFEM SIMULATION OF NON-AXISYMMETRIC STRETCH FLANGE FORMING OF ALUMINUM ALLOY 5052 BASED ON SHELL TYPE ELEMENTS
Finite element simulation of stretch flanging process was carried out in order to investigate the effect of process parameters on maximum thinning (%) in stretch flanging process. Influences of initial flange length, punch die clearance, width of sheet metal blank and blank holding force were investigated on maximum thinning (%). Finite element simulation was done using FEM software package ABA...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1993
ISSN: 0451-5994
DOI: 10.2464/jilm.43.71