Effect of La2O3 on microstructure, mechanical and tribological properties of Ni-W coatings
نویسندگان
چکیده
منابع مشابه
Effect of TiO2 Particle Concentration on Microstructure and Mechanical Properties of Ni-P-TiO2 Composite Coatings
Ferritic stainless steels are widely used in equipment, including parts in turbines, electrical industries, aerospace, automotive and decorating industries. One of the problems with this type of steels is their low wear resistance. One of the ways to overcome this problem is to apply a wear-resistant coating on the surface of steel. In this research, nickel phosphorus-titanium oxide coating was...
متن کاملdetermination of some physical and mechanical properties red bean
چکیده: در این تحقیق، برخی خواص فیزیکی و مکانیکی لوبیا قرمز به-صورت تابعی از محتوی رطوبت بررسی شد. نتایج نشان داد که رطوبت بر خواص فیزیکی لوبیا قرمز شامل طول، عرض، ضخامت، قطر متوسط هندسی، قطر متوسط حسابی، سطح تصویر شده، حجم، چگالی توده، تخلخل، وزن هزار دانه و زاویه ی استقرار استاتیکی در سطح احتمال 1 درصد اثر معنی داری دارد. به طوری که با افزایش رطوبت از 54/7 به 12 درصد بر پایه خشک طول، عرض، ضخام...
15 صفحه اولMicrostructure, Mechanical and Tribological Properties of Reactive Magnetron Sputtered Titanium Carbide Coatings
This study describes the correlation between the microstructure, mechanical and tribological properties of Ti1-xCx coatings (with x being in the range of 0-1), deposited by reactive magnetron sputtering from a Ti target in Ar/C2H2 mixtures at ~200 °C. The mechanical and tribological properties were found to strongly depend on the chemical composition and the microstructure present. Very dense s...
متن کاملthe effect of explicit teaching of metacognitive vocabulary learning strategies on recall and retention of idioms
چکیده ندارد.
15 صفحه اولEvaluating the Effect of Ta/W Ratio on Microstructure and Stress Rupture Properties of Ni-Based Single Crystal Superalloy PWA1483
In this study, the effect of Ta/W ratio on the microstructure and stress rupture properties of Ni-based single crystal (SX) superalloy PWA1483 was investigated. For this purpose, single crystal (SX) superalloys with different Ta/W ratios (0.75, 1.0, 1.32 and 1.5 in wt.%) were fabricated. The alloys were directionally solidified by Bridgman method under the same solidification condition at withd...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science Bulletin
سال: 2009
ISSN: 2095-9273,2095-9281
DOI: 10.1007/s11434-009-0603-7