Effect of Process Parameters on Machining Process Using Single Point Cutting Tool: An Anova Analysis Based Study
نویسندگان
چکیده
منابع مشابه
Experimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملEffect of cutting parameters on tool-chip interface temperature in an orthogonal turning process
The aim of this paper is to investigate the effect of cutting speed and uncut chip thickness on cutting performance. A Finite Element Method (FEM) based on the ABAQUS explicit software which involves Johnson-Cook material mode and Coulombs friction law was used to simulate of High Speed Machining (HSM) of AISI 1045 steel. In this simulation work, feed rate ranging from 0.05 mm/rev to 0.13 mm/re...
متن کاملProcess capability improvement of an engine connecting rod machining process
Statistical process control is an excellent quality assurance tool to improve the quality of manufacture and ultimately scores on end-customer satisfaction. SPC uses process monitoring charts to record the key quality characteristics (KQCs) of the component in manufacture. This paper elaborates on one such KQC of the manufacturing of a connecting rod of an internal combustion engine. Here th...
متن کاملProcess-based tolerance assessment of connecting rod machining process
Process tolerancing based on the process capability studies is the optimistic and pragmatic approach of determining the manufacturing process tolerances. On adopting the define–measure–analyze–improve–control approach, the process potential capability index (C p) and the process performance capability index (C pk) values of identified process characteristics of connecting rod ...
متن کاملTime-Variant Reliability Assessment and Its Sensitivity Analysis of Cutting Tool under Invariant Machining Condition Based on Gamma Process
The time-variant reliability and its sensitivity of cutting tools under both wear deterioration and an invariant machining condition are analyzed. The wear process is modeled by a Gamma process which is a continuous-state and continuous-time stochastic process with the independent and nonnegative increment. The time-variant reliability and its sensitivity of cutting tools under six cases are co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Recent advances in Mechanical Engineering
سال: 2015
ISSN: 2200-5854
DOI: 10.14810/ijmech.2015.4311