Effect of Surface Roughness on Contact Angle Measurement of Nanofluid on Surface of Stainless Steel 304 by Sessile Drop Method
نویسندگان
چکیده
منابع مشابه
Effect of surface roughness on steel-steel dry friction coefficient
The influence of surface roughness magnitude and direction on dry static friction coefficient between two similar steel samples has been studied through an experiment. A testing apparatus has been designed and fabricated to measure the friction coefficient for a few forms of surface asperity. According to the results of the experiments, dry friction coefficient is affected by both magnitude and...
متن کاملeffect of oral presentation on development of l2 learners grammar
this experimental study has been conducted to test the effect of oral presentation on the development of l2 learners grammar. but this oral presentation is not merely a deductive instruction of grammatical points, in this presentation two hypotheses of krashen (input and low filter hypotheses), stevicks viewpoints on grammar explanation and correction and widdowsons opinion on limited use of l1...
15 صفحه اولthe effect of explicit teaching of metacognitive vocabulary learning strategies on recall and retention of idioms
چکیده ندارد.
15 صفحه اولthe effect of consciousness raising of sociolinguistic skills on speaking ability of iranian efl learners
abstract the main purpose of this study was to investigate whether there was any significant difference between the speaking achievement of learners who were trained by means of consciousness raising of sociolinguistic skills and that of learners who were trained without the above mentioned task. the participants of this study consist of 60 intermediate level students participating languag...
Optimization of Surface Roughness of Aisi 304 Austenitic Stainless Steel in Dry Turning Operation Using Taguchi Design Method
The present work is concentrated with the dry turning of AISI 304 Austenitic Stainless Steel (ASS). This paper presents the influence of cutting parameters like cutting speed, feed rate and depth of cut on the surface roughness of austenitic stainless steel during dry turning. A plan of experiments based on Taguchi’s technique has been used to acquire the data. An orthogonal array, the signal t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2016
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/739/1/012029