Effect of Ta Additions on the Microstructure, Damping, and Shape Memory Behaviour of Prealloyed Cu-Al-Ni Shape Memory Alloys
نویسندگان
چکیده
منابع مشابه
Effect of Ta Additions on the Microstructure, Damping, and Shape Memory Behaviour of Prealloyed Cu-Al-Ni Shape Memory Alloys
The influence of Ta additions on the microstructure and properties of Cu-Al-Ni shape memory alloys was investigated in this paper. The addition of Ta significantly affects the green and porosity densities; the minimum percentage of porosity was observed with the modified prealloyed Cu-Al-Ni-2.0 wt.% Ta. The phase transformation temperatures were shifted towards the highest values after Ta was a...
متن کاملDamping Characteristics of Inherent and Intrinsic Internal Friction of Cu-Zn-Al Shape Memory Alloys
Damping properties of the inherent and intrinsic internal friction peaks (IFPT + IFI) of Cu-xZn-11Al (x = 7.0, 7.5, 8.0, 8.5, and 9.0 wt. %) shape memory alloys (SMAs) were investigated by using dynamic mechanical analysis. The Cu-7.5Zn-11Al, Cu-8.0Zn-11Al, and Cu-8.5Zn-11Al SMAs with (IFPT + IFI)β3(L21)→γ′ 3(2H) peaks exhibit higher damping capacity than the Cu-7.0Zn-11Al SMA with a (IFPT + IF...
متن کاملMagnetoelasticity and Magnetoresistance in Cu–Al–Mn Shape-Memory Alloys
This paper is aimed at studying the effect of a magnetic field on the martensitic transition of a Cu–Al–Mn shape-memory alloy. The martensitic transition has been studied through resistance measurements under applied magnetic fields ranging from 0 to 50 kOe. Negative magnetoresistance showing an almost linear dependence with the square of the magnetization has been observed. This magnetoresisti...
متن کاملShape memory and superelasticity in polycrystalline Cu–Al–Ni microwires
We report a strategy to significantly improve the ductility and achieve large superelastic and shape memory strains in polycrystalline Cu–Al–Ni shape memory alloys that are normally brittle. We use a liquid-phase Taylor wire forming process to obtain microwires of 10–150 m diameter with a bamboo grain structure. The reduction of grain boundary area, removal of triple junctions, and introduction...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scanning
سال: 2017
ISSN: 0161-0457,1932-8745
DOI: 10.1155/2017/1789454