Effects of Addendum Modification on Bending Fatigue Strength of Spur Gears : 2nd Report, Casehardened Gears
نویسندگان
چکیده
منابع مشابه
Influence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملOptimal Selection of Addendum Modification Coefficients of Involute Cylindrical Gears
Based on the principles of equalized sliding coefficients and equalized teeth bending strength, the optimization mathematical model for calculating and allocating the addendum modification coefficients of involute cylindrical gear is firstly established. Then the measures to calculate the tooth parameters in real-time during the optimization steps are achieved. Finally, the optimization program...
متن کاملBending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملInfluence of dynamic behaviour on elastohydrodynamic lubrication of spur gears
In this study, the elastohydrodynamic lubrication (EHL) behaviour of high-speed spur gear contacts is investigated under dynamic conditions. A non-linear time-varying vibratory model of spur gear pairs is introduced to predict the instantaneous tooth forces under dynamic conditions within both the linear and non-linear operating regimes. In this model, the periodically time-varying gear mesh st...
متن کاملThe source of Acoustic Emission during meshing of spur gears
Condition monitoring of gears with vibration analysis and Spectrometric Oil Analysis Programs (SOAP) are widely accepted and used in the military aviation industry. Whilst the literature to date has shown the application of the Acoustic Emission (AE) technique to gearbox health monitoring still be in its infancy, there exist opportunities to develop the technique into a complementary diagnostic...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1977
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.20.122