Effects of Boundary Layer on a Long Circular Cylinder Junction Flow

Boundary layer flow on a long thin cylinder

The development of the boundary layer along a long thin cylinder aligned with the flow is considered. Numerical solutions are presented and compared with previous asymptotic results. Very near the leading edge the flow is given by the Blasius solution for a flat plate. However, there is soon a significant deviation from Blasius flow, with a thinner boundary layer and higher wall shear stress. L...

Effects Of Frequency Variation At Inlet Flow On The Vortex Shedding Frequency Behind A Circular Cylinder

In many applications the flow that past bluff bodies has frequency nature (oscillated) and it is not uniform. This kind of flow has effects on the formation of vortex shedding behind bluff bodies. In this paper the flow around a circular cylinder was numerically simulated. The effects of frequency variation at inlet flow on the vortex shedding frequency were investigated. The transient Two-Dime...

Effect of magnetic field on the boundary layer flow, heat, and mass transfer of nanofluids over a stretching cylinder

The effect of a transverse magnetic field on the boundary layer flow and heat transfer of anisothermal stretching cylinder is analyzed. The governing partial differential equations for themagnetohydrodynamic, temperature, and concentration boundary layers are transformed into a setof ordinary differential equations using similarity transformations. The obtained ordinarydifferential equations ar...

An Experimental Investigation of the Boundary Layer on a Porous Circular Cylinder

Influence of Afterbody and Boundary Layer on Cavitating Flow

The characteristics of a cavitation water tunnel test setup and the experiments of cavitation around different models are given in this paper. Models of test are formed from combination of head and variable length afterbody. The experiments are performed initially with the smooth head and then with the roughened head. Cavitation initiates both in the wake and after the head. If the nose of mode...