Effects of Hydrostatic Stress and Strain Hardening Exponent on Near-tip Fields Under Mixed Mode Loading.
نویسندگان
چکیده
منابع مشابه
Effect of T-stress on Edge Dislocation Formation at a Crack Tip under Mode I Loading
We calculate the effect of the nonsingular stress acting parallel to a crack (the “Tstress”) on edge dislocation nucleation at a crack loaded in Mode I. We find that this leads to crack size effect – that is, for small cracks (of order 100 atomic spacings or less), the T stress causes the critical load for dislocation nucleation (expressed in terms of the applied stress intensity factor) to dev...
متن کاملThe Effect of Inclined U-Notch Geometry on Mode Ratio (KII/KI) under Mixed Mode (I + II) Loading
In inclined U-notches, the mixed mode (I + II) loading occurs and the mode ratio can be increased by varying the notch angle. In this paper, the effect of the inclined U-notch geometry, i.e. the notch depth, the notch angle, the notch root radius, and the position of the notch with respect to supports, on the mode ratio (KII/KI) have been studied. Three-point bending and plane strain condition ...
متن کاملEffects of the strain-hardening exponent on two-parameter characterizations of surface-cracks under large-scale yielding
Article history: Received 29 June 2010 Received in final revised form 9 September 2010 Available online 30 October 2010
متن کاملNonproportional Loading Effects on Elastic-plastic Behavior Based on Stress Resultants for Thin Plates of Strain Hardening Materials
Ahstraet-A stress resultant constitutive law in rate form is constructed for power-law hardening materials. The change of plate thickness is considered in the constitutive law. The elastic-plastic behavior of a plate element based on the stress resultant constitutive law under uniaxial combined tension and bending is determined under a limited number of nonproportional and unloading paths. The ...
متن کاملPlane-stress Crack-tip Fields for Pressure-sensitive Dilatant Materials
Abstraet--In this paper we present plane-stress crack-tip stress and strain fields for pressure-sensitive dilatant materials. A hydrostatic stress-dependent yield criterion and the normality flow rule are used to account for pressure-sensitive yielding and plastic dilatancy. The material hardening response is specified by a power-law relation. The plane-stress mode I singular fields are found i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1991
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.57.1506