Effects of Inductor Shape in Steel Forming Process with High Frequency Induction Heating
نویسندگان
چکیده
منابع مشابه
Frequency Selectable Induction Heating Targets
This paper examines a scheme for developing frequency selectable induction heating targets for stimulating temperature sensitive polymer actuators. “Frequency selectable” implies that each target has a frequency at which it heats preferentially compared to other remaining targets. Single-turn conductors whose critical dimensions are small compared to their associated skin depth (over the freque...
متن کاملFEM modeling of a continuous induction heating process of steel wire hardening
Hardening of steel wires requires heating the wires above their Curie temperature, temperature at which the material becomes nonmagnetic causing a sudden change in the load. This change affects to the induction heating converters and is difficult to be evaluated due to the complexity of the problem and the interdependence of the parameters. In this paper a continuous Post-Curie wire heating mod...
متن کاملA computer aided finite element/experimental analysis of induction heating process of steel
The characteristics of steels during electroplating or induction heating are very complex. Induction heat-treating of steel has become increasingly important as a means of reducing cost and improving the quality of carbon steel components. The use of high frequency (40 to 2OOkHz) offers many advantages, but tooling and cycle optimization is complex and time consuming. Approximate analytical met...
متن کاملAn Investigation of Casting Defects Revealed in Forming Process of USD7 Steel
USD7 is one of the steel products of Isfahan Steel Company. It is cast in continuous casting moulds and rolled up to a rod of 5 mm diameter. Finally, it is wire drawn up to 3 mm and used as welding electrodes. This steel contains 0.05 to 0.09 wt. % carbon. The acceptable limit of the aluminium in this class of steel is less than 0.003 wt%. Therefore, it is categorized as rimmed steel...
متن کاملComputational Modeling of Induction Heating Process
An accurate 2D steady state mathematical model for induction heating process is described and additional results of electromagnetic field, eddy currents distribution and volumetric heat generation have been computed for a sample setup using a finite element method. For the calculations, the input voltage of induction coil is set to be 200 V with a frequency of 10 kHz. It was shown that for the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean Welding and Joining Society
سال: 2008
ISSN: 1225-6153
DOI: 10.5781/kwjs.2008.26.4.066