Efficiency Improvement of FET using MHz Class D Inverter
نویسندگان
چکیده
منابع مشابه
assessment of the efficiency of s.p.g.c refineries using network dea
data envelopment analysis (dea) is a powerful tool for measuring relative efficiency of organizational units referred to as decision making units (dmus). in most cases dmus have network structures with internal linking activities. traditional dea models, however, consider dmus as black boxes with no regard to their linking activities and therefore do not provide decision makers with the reasons...
Dynamic power efficiency improvement for PWM class-D amplifier
This paper presents the technique to dynamically enhance the power efficiency of PWM class-D amplifier over a wide range of modulation indexes. The power stage of amplifier is segmented into several small stages and selectively enabled according to the power demand (i.e. modulation indexes). The capability of power delivery is dynamically adjusted to minimize the power loss in case of different...
متن کاملComputer Simulation of Class D Inverter Fed Induction Heated Jar
This paper deals with digital simulation of Class D inverter fed induction heater system. This system has an advantage like reduced volume and switching losses. The circuit operates under zero voltage switching. The circuit models are developed for the open and closed loop system and they are used for simulation studies. The simulation results of open and closed loop systems are presented.
متن کاملEfficiency Improvement of Induction Motor using Fuzzy-Genetic Algorithm
In most industrial zones, electric energy is one of the most important energy sources. Since electrical motors are the main energy consumers of industrial factories, consumption optimization in these motors can be considered as a main option related to energy saving. One very effective way to reduce the consumption of these equipment is to use a motor speed controllers or drives. Since the loss...
متن کاملProcess Improvement of Experimental Measurements Using D-optimal Models
In this paper, the application of D-optimal models, as an alternative to response surface models (RS models) for design of experiment (DOE) was examined. Two D-optimal models for tilt-rotors in the wind tunnel experiment, as a form of quadratic functions, were generated based on a chosen optimality criterion. This optimality criterion was used to generate the optimized sampled points in the des...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Illuminating Engineering Institute of Japan
سال: 2003
ISSN: 0019-2341,1349-838X,2185-1506
DOI: 10.2150/jieij1980.87.appendix_41