Elastic-plastic fracture analysis of carbon steel piping.
نویسندگان
چکیده
منابع مشابه
Effect of cyclic loading on elastic–plastic fracture resistance of PHT system piping material of PHWR
The objective of the paper is to study the effect of cyclic loading on the fracture resistance of the SA 333 Gr.6 carbon steel material of the primary heat transport (PHT) system piping of Indian pressurized heavy water reactors (PHWR). Tests have been carried out on compact tension specimens machined from the pipe used in the PHT system. The effect of load ratio, incremental plastic displaceme...
متن کاملNumerical Estimation of Fracture Parameters in Elastic and Elastic-plastic Analysis
The finite element method has been largely used to analyze mechanical problems and, in particular, to obtain the response of cracked structures. One of the major issues in using the method is mesh generation. Nowadays, several automatic mesh generation algorithms are available for two-dimensional models. Crack analysis imposes severe requirements on automatic mesh generation. It is not uncommon...
متن کاملNanomechanical Quantification of Elastic, Plastic, and Fracture Properties of LiCoO2
LiCoO 2 is an important lithium storage compound that adopts a distorted rock-salt structure of the α -NaFeO 2 type. After the discovery of reversible lithium (de)intercalation in this layered host compound by Mizushima et al., [ 1 ] this material became central to the introduction and subsequent development of lithium-ion batteries (LIBs) of high energy and power density. The advantages of LiC...
متن کاملElastic-plastic Mode-ii Fracture of Adhesive Joints
A numerical study of the elastic-plastic mode-II fracture of adhesive joints is presented in this paper. A traction-separation law was used to simulate the mode-II interfacial fracture of adhesively-bonded end-notched flexure (E.N.F.) specimens loaded in three-point bending, with extensive plastic deformation accompanying failure. The fracture parameters for the traction-separation law were det...
متن کاملFracture Mechanisms of a Thin Elastic Plastic Laminate
The fracture toughness of a polymer-metal laminate composite is obtained by mechanical testing of a specimen containing a pre-crack. The laminate is a material used for packaging. It consists of a thin aluminium foil and a polymer coating. A centre cracked panel test geometry is used. Each of the layers forming the laminate is also tested separately. The result is compared with the measured fra...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1989
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.55.819