Electrode Profile Prediction and Wear Compensation in EDM-milling and Micro-EDM-Milling
نویسندگان
چکیده
منابع مشابه
A Review of Micro - EDM
There is a huge demand in the production of microstructures by a non-traditional method which is known as Micro-EDM. Micro-EDM process is based on the thermoelectric energy between the workpiece and an electrode. Micro-EDM is a newly developed method to produce micro-parts which in the range of 50 μm -100 μm. Micro-EDM is an efficient machining process for the fabrication of a micro-metal hole ...
متن کاملInvestigation of tool ware ratio in micro and conventional EDM
Micro-electrical discharge machining is an evolution of conventional EDM used for fabricating three-dimensional complex micro-components and microstructures with high precision capabilities. The material removal process has stochastic nature and is still not fully understood. This paper presents experimental results on observing the material removal rate (MRR) in dependence of alternating machi...
متن کاملEthics and Privacy in EDM
Educational data mining is inherently falls into the category of the so-called secondary data analysis. It is common that data that have been collected for administrative or some other purposes at some point is considered as valuable for other (research) purpose. Collection of the student generated, student behavior and student performance related data on a massive scale in MOOCs, ITSs, LMS and...
متن کاملFabrication of Microfluidic Channel Using Micro End Milling and Micro Electrical Discharge Milling
This paper discusses the fabrication of microfluidic channels using micro end milling and micro electrical discharge (ED) milling on metals and polymers. The width of the microchannels fabricated by micro end milling was 100-800 μm with 1-2 aspect ratio. The average surface roughness values were 100-200 nm and 80-120 nm on metals and polymers respectively. The end milling was found to form more...
متن کاملMICRO-EDM FOR MICRO-CHANNEL FABRICATION ON NONCONDUCTIVE ZrO2 CERAMIC
In this study, microelectro-discharge (micro-ED) milling of nonconductive ZrO2ceramicsis investigated using a Cu tool electrode in kerosene dielectric. An adhesive Cu foil is firmly attached on the workpiece to initiate the sparks. After the machining of Cu foil, an electrically conductive carbonic layer is formed on the ceramic workpiece disassociating the kerosene dielectric, which allows mic...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2018
ISSN: 2212-8271
DOI: 10.1016/j.procir.2017.12.162