Electrohydrodynamic Atomization for Minimum Quantity Lubrication (EHDA-MQL) in End Milling Ti6Al4V Titanium Alloy
نویسندگان
چکیده
منابع مشابه
Analysis of Minimum Quantity Lubrication (MQL) for Different Coating Tools during Turning of TC11 Titanium Alloy
The tool coating and cooling strategy are two key factors when machining difficult-to-cut materials such as titanium alloy. In this paper, diamond coating was deposited on a commercial carbide insert as an attempt to increase the machinability of TC11 alloy during the turning process. An uncoated carbide insert and a commercial Al₂O₃/TiAlN-coated tool were also tested as a comparison. Furthermo...
متن کاملMinimum Quantity Lubrication (MQL) in Machining: Benefits and Drawbacks
Micro lubrication or also known as minimum quantity lubrication (MQL) serves as an alternative to flood cooling by reducing the volume of cutting fluid used in the machining process; but not without significant health concerns. Flood cooling is primarily used to cool and lubricate the cutting tool and work piece interface during machining process. The adverse health effects caused by the use of...
متن کاملPhD DEFENSE ANNOUNCEMENT Tittle: FUNDAMENTAL TOOL WEAR STUDY IN TURNING OF Ti-6Al-4V ALLOY (Ti64) AND NANO-ENHANCED MINIMUM QUANTITY LUBRICATION (MQL) MILLING
Tittle: FUNDAMENTAL TOOL WEAR STUDY IN TURNING OF Ti-6Al-4V ALLOY (Ti64) AND NANO-ENHANCED MINIMUM QUANTITY LUBRICATION (MQL) MILLING Scheduled Date of PhD Defense: 1/9/2015 Scheduled Time of PhD Defense: 3.00PM Scheduled Location of PhD Defense (Building & Room #): 3540 Engineering Building Full name: Trung Kien Nguyen PID: A45082194 Email: [email protected] PhD Degree Major: Mechanical Enginee...
متن کاملHybrid Surface Acoustic Wave- Electrohydrodynamic Atomization (SAW-EHDA) For the Development of Functional Thin Films
UNLABELLED Conventional surface acoustic wave - electrostatic deposition (SAW-ED) technology is struggling to compete with other thin film fabrication technologies because of its limitation in atomizing high density solutions or solutions with strong inter-particle bonding that requires very high frequency (100 MHz) and power. In this study, a hybrid surface acoustic wave - electrohydrodynamic ...
متن کاملOptimization of End Milling Parameters under Minimum Quantity Lubrication Using Principal Component Analysis and Grey Relational Analysis
Machining is the major reliable practice in accomplishment of metal cutting industries. The accelerated growing competition demands top superior and large quantity with low cost products. Metal working fluids have significant fragment of manufacturing cost and causes ecological impacts and health problems. This work attempts to advance a competent machining alignment with no ecological impacts....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Manufacturing and Materials Processing
سال: 2020
ISSN: 2504-4494
DOI: 10.3390/jmmp4030070