Electron beam characterization with beam loss monitors
نویسندگان
چکیده
منابع مشابه
Beam Position Monitors Characterization for Alba
Beam position monitors (BPM) characterization has been widely studied at ALBA Synchrotron Light Source. Special care has been taken on the analysis of their electrical offset in order to achieve submicron beam stabilities. This paper shows the results of the BPM offset study for Booster and Storage Ring. The electrical effect of the different vacuum vessels housing the BPMs is also reported.
متن کاملCavity Beam Position Monitors
Beam-based alignment and feedback systems are essential for the operation of future linear colliders and free electron lasers. A certain number of beam position monitors with a resolution in the submicron range are needed at selected locations. Most beam position monitors detect the electric or the magnetic eld excited by a beam of charged particles at di erent locations around the beam pipe. I...
متن کاملReliability Considerations on the LHC Beam Loss Monitors System
The increase of beam energy and beam intensity, together with the use of super conducting magnets, opens new failure scenarios and brings new criticalities for the whole accelerator protection system. For the LHC beam loss protection system, the failure rate and the availability requirements have been evaluated using the Safety Integrity Level (SIL) approach [1]. A downtime cost evaluation is u...
متن کاملPosition Resolution of Optical Fibre-based Beam Loss Monitors Using Long Electron Pulses
Beam loss monitoring systems based on optical fibres (oBLM), have been under consideration for future colliders for several years. To distinguish losses between consecutive quadrupoles, the position resolution of detected losses is required to be less than 1 m. A resolution of better than 0.5 m has been achieved in machines with single, short pulses of the order of a nanosecond. In the case of ...
متن کاملBeam-loss Monitors Tn the Slc Final Focus'
Beam-loss monitors in the SLC Final Focus System &e used for protection of accelerator and detector components, optimizing adjustment of beam halo collimators, and as diagnostics of beam size and halo. Construction of a variety of monitors based on discrete ion chambers, proportional tubes, continuous 'ion chambers, and signals from the Mark II detector is reported. The interfaces to the SLC co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review Accelerators and Beams
سال: 2020
ISSN: 2469-9888
DOI: 10.1103/physrevaccelbeams.23.032803