Electron beam control using experimentally measured transport matrices
نویسندگان
چکیده
منابع مشابه
Measurements of Photon Beam Flattening Filter Using an Anisotropic Analytical Algorithm and Electron Beam Employing Electron Monte Carlo
Introduction: This study aimed to report the measurement of photon and electron beams to configure the Analytical Anisotropic Algorithm and Electron Monte Carlo used in clinical treatment. Material and Methods: All measurements were performed in a large water phantom using a 3-dimensional scanning system (PTW, Germany). ...
متن کاملElectron beam quality control using an amorphous silicon EPID.
An amorphous silicon EPID has been investigated to determine whether it is capable of quality control constancy measurements for linear accelerator electron beams. The EPID grayscale response was found to be extremely linear with dose over a wide dose range and, more specifically, for exposures of 95-100 MU. Small discrepancies of up to 0.8% in linearity were found at 6 MeV (8-15 MeV showed bet...
متن کاملMeasured Properties of the DUVFEL High Brightness, Ultrashort Electron Beam
The DUVFEL electron linac is designed to produce sub-picosecond, high brighness electron bunches to drive an ultraviolet FEL. The accelerator consists of a 1.6 cell S-band photoinjector, variable pulse length Ti:Sapp laser, 4 SLAC-type S-band accelerating sections, and 4-dipole chicane bunch compressor. In preparation for FEL operation, the compressed electron beam has been fully characterized....
متن کاملElectron heat transport measured in a stochastic magnetic field.
New profile measurements have allowed the electron thermal diffusivity profile to be estimated from power balance in the Madison Symmetric Torus where magnetic islands overlap and field lines are stochastic. The measurements show that (1) the electron energy transport is conductive not convective, (2) the measured thermal diffusivities are in good agreement with numerical simulations of stochas...
متن کاملTransport optimization and characterization of the 2kA AIRIX electron beam
The AIRIX induction accelerator is now operational. After completing the acceptance test of the entire machine, we have aligned the sixteen blocks of four cells, each using the very accurate HLS (Hydrostatic Leveling System) and WPS (Wire Positionning System) method. The beam transport optimization was made with a 1.92kA,60ns electron beam, accelerated from 3.8 to 19.2MeV. This procedure consis...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Laser and Particle Beams
سال: 1994
ISSN: 0263-0346,1469-803X
DOI: 10.1017/s0263034600007205