Electron beam sintering of gradient Al2O3-ZrO2 ceramics with the forevacuum plasma electron source
نویسندگان
چکیده
منابع مشابه
Transient Physical Effects in Electron Beam Sintering
The extensive use of the electron beam in manufacturing processes like welding or perforating revealed the high potentials for also using it for solid freeform fabrication. First approaches like feeding wire into a melt pool have successfully shown the technical feasibility. Among other features, the electron beam exhibits high scanning speed, high power output, and beam density. While in laser...
متن کاملLayer Formations in Electron Beam Sintering
Among direct metal processing manufacturing technologies (Rapid Manufacturing), Electron Beam Sintering (EBS) exhibits a high application potential. Especially, the fast beam deflection provided by electromagnetic lenses allows the realization of considerable building speeds and minor residual stresses. Therefore, this paper aims to examine and utilize the given potential for additive layer man...
متن کاملA Reflex Electron Beam Discharge as a Plasma Source for Electron Beam Generation
A reflex electron beam glow discharge has been used as a plasma source for the generation of broad-area electron beams. An electron current of 120 A ( 12 A/cm2) was extracted from the plasma in 10 ps pulses and accelerated to energies greater than 1 keV in the gap between two grids. The scaling of the scheme for the generation of multikiloamp high-energy electron beams is discussed. E HAVE demo...
متن کاملLow-Energy Plasma Focus Device as an Electron Beam Source
A low-energy plasma focus device was used as an electron beam source. A technique was developed to simultaneously measure the electron beam intensity and energy. The system was operated in Argon filling at an optimum pressure of 1.7 mbar. A Faraday cup was used together with an array of filtered PIN diodes. The beam-target X-rays were registered through X-ray spectrometry. Copper and lead line ...
متن کاملDetermination of Process Parameters for Electron Beam Sintering (EBS)
Additive Layer Manufacturing (ALM) methods, like Electron Beam Sintering (EBS) constitute an interesting process concerning the production of small series and customised products. However, transient effects occur during processing due to the different physical principles of an electron beam (EB). Thus, process knowledge from similar ALM technologies, for instance Selective Laser Melting, can no...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2020
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/1488/1/012010