Electrophoretic deposition and laser cladding of bioglass coating on Ti
نویسندگان
چکیده
منابع مشابه
Electrophoretic deposition and corrosion behavior study of aluminum coating on AZ91D substrate
Aluminum coating was prepared on AZ91D magnesium alloy substrate using the electrophoretic deposition (EPD) method in absolute ethanol solvent. In order to determine the optimal concentration of AlCl3.6H2O additive, the zeta potential and size of particles in the suspension were measured in the presence of different concentrations of AlCl3.6H2O. The results showed that an appropriate coating is...
متن کاملElectrophoretic Deposition of Hydroxyapatite
The purpose of this study was to investigate the deposition of the hydroxyapatite (HA) coating via the electrophoresis procedure. The HA deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. Methanol was found to be the best deposition media. Among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pr...
متن کاملLaser Powder Cladding of Ti-6Al-4V α/β Alloy
Laser cladding process was performed on a commercial Ti-6Al-4V (α + β) titanium alloy by means of tungsten carbide-nickel based alloy powder blend. Nd:YAG laser with a 2.2-KW continuous wave was used with coaxial jet nozzle coupled with a standard powder feeding system. Four-track deposition of a blended powder consisting of 60 wt % tungsten carbide (WC) and 40 wt % NiCrBSi was successfully mad...
متن کاملHydroxyapatite coating by electrophoretic deposition at dynamic voltage.
The aim of this study was to evaluate hydroxyapatite (HA) coatings produced by dynamic voltage during electrophoretic deposition (EPD). Dynamic voltages from 0 to 200 V were incrementally applied in three interims. The as-deposited coating was sintered at 800 degrees C and its properties evaluated. Structure and phase analyses of both as-deposited and sintered coatings were evaluated by scannin...
متن کاملElectrophoretic deposition of MnCr2O4 coating for solid oxide fuel cell metallic interconnects
In the present study, Mn - Cr spinel powder was synthesized through a solid state reaction. In the next step, the electrophoretic deposition (EPD) method was used to apply the MnCr2O4 spinel, as an oxidation-resistant layer, on SUS 430 stainless steel in a potential of 300 V/cm. The coated and uncoated samples were then pre-sintered in air at 900 °C for 3 h followed by cyclic oxidation at 800 °...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Alloys and Compounds
سال: 2017
ISSN: 0925-8388
DOI: 10.1016/j.jallcom.2017.03.209