Electrophoretic Deposition of Alumina and Nickel Oxide Particles
نویسندگان
چکیده
منابع مشابه
Electrophoretic Deposition of Hydroxyapatite
The purpose of this study was to investigate the deposition of the hydroxyapatite (HA) coating via the electrophoresis procedure. The HA deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. Methanol was found to be the best deposition media. Among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pr...
متن کاملEffect of ion concentration on viscosity, electrical conductivity and deposit weight of doped nano alumina prepared by electrophoretic deposition
Viscosity, electrical conductivity and deposit weight were determined for Electrophoretic deposition (EPD) Mg2+-, Y3+-, La3+- and Ce4+-doped alumina's ethanolic suspensions prepared at dopant concentration between 350 to 1350 ppm. The concentration of XCly (X, y were: Mg, 2; Y, 3; Ce, 3 and La, 3, respectively) the charging salt, is also found to be a critical factor to control the viscosity. I...
متن کاملelectrophoretic deposition of hydroxyapatite
the purpose of this study was to investigate the deposition of the hydroxyapatite (ha) coating via the electrophoresis procedure. the ha deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. methanol was found to be the best deposition media. among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pressur...
متن کاملElectrophoretic deposition of MnCr2O4 coating for solid oxide fuel cell metallic interconnects
In the present study, Mn - Cr spinel powder was synthesized through a solid state reaction. In the next step, the electrophoretic deposition (EPD) method was used to apply the MnCr2O4 spinel, as an oxidation-resistant layer, on SUS 430 stainless steel in a potential of 300 V/cm. The coated and uncoated samples were then pre-sintered in air at 900 °C for 3 h followed by cyclic oxidation at 800 °...
متن کاملPorous Graphene Oxide Prepared on Nickel Foam by Electrophoretic Deposition and Thermal Reduction as High-Performance Supercapacitor Electrodes
A simple electrophoretic deposition method was developed to prepare graphene oxide (GO) films on the frameworks of nickel foam without any conductive agents and polymer binders. Then, GO was transformed into thermally-reduced graphene oxide (RGO) at an appropriate temperature. The effects of deposition voltage and thermal reduction temperature on the electrochemical properties of RGO were inves...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Scientific Research and Reports
سال: 2013
ISSN: 2320-0227
DOI: 10.9734/jsrr/2013/2559