Energetic modelling for carbon fibre reinforced carbon
نویسندگان
چکیده
منابع مشابه
Carbon-fibre reinforced plates for problem fractures.
We report our experience with carbon-fibre reinforced plastic (CFRP) plates in the management of 19 problem fractures complicated by either infection, nonunion, comminution or contamination. The combination offers secure fixation without inhibition of callus formation.
متن کاملImage Characterization of Carbon Fibre Reinforced Composites
A new methodology to detect fibres orientation in composite materials, using image processing tools is introduced. Several examples with manufacturing defects are studied using RIMAPS technique and the Variogram method. The characterization is made from digitized images of the samples. Combined use of RIMAPS and Variogram analyses identified the orientation of fibres and determined the values o...
متن کاملJoining of Carbon Fibre Reinforced Plastics for Automotive Applications
The introduction of carbon-fibre reinforced plastics in load bearing automotive structures provides a great potential to reduce vehicle weight and fuel consumption. To enable the manufacture and assembly of composite structural parts, reliable and cost-effective joining technologies must be developed. This thesis addresses several aspects of joining and load introduction in carbon-fibre reinfor...
متن کاملWear of ceramic-on-carbon fibre reinforced PEEK hip replacements
Total hip replacement has been a successful surgical intervention for many years. However, concerns regarding UHMWPE wear particle induced osteolysis [1], have led to alternative bearing materials to be sought. Carbon-fibre reinforced poly-ether-ether-ketone (CFR-PEEK) is a fibre-reinforced polymer which has shown reduced wear in hip and knee configurations compared with conventional polyethyle...
متن کاملDrilling of carbon fibre reinforced laminates – a study
The distinguishing characteristics of carbon fibre reinforced laminates, like low weight, high strength or stiffness, had resulted in an increase of their use during the last decades. Although parts are normally produced to “near-net” shape, machining operations like drilling are still needed. In result of composites non-homogeneity, this operation can lead to delamination, considered the most ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: PAMM
سال: 2006
ISSN: 1617-7061,1617-7061
DOI: 10.1002/pamm.200610228