Energy Modelling on Taper Tool Geometry of Aluminium Alloys using C Program
نویسندگان
چکیده
منابع مشابه
Modelling of friction for high temperature extrusion of aluminium alloys
During high-temperature ball-on-disc tests of aluminium against steel, hot aluminium deformsand wear track evolves. The individual contributions of ploughing and shearing to theapparent friction and the contact pressure are unknown. The aim of this chapter was todevelop a model capable of determining these parameters. It was found that during high-temperature ball-on-disc tests,...
متن کاملNumerical Modelling of Drawbeads for Forming of Aluminium Alloys
The drawbeads in stamping tools are usually designed based on experience from the forming of steel. However, aluminium alloys display different forming behaviour to steels, which is not reflected in the drawbead design for tools used for stamping aluminium. This paper presents experimental results from different semi-circular drawbead geometries commonly encountered in automotive dies and compa...
متن کاملThe Investigation of Modelling Material Behavior in Autofrettaged Tubes Made from Aluminium Alloys
Normal 0 false false false EN-US X-NONE AR-SA The ratio of compression yield strength to the initial tensile yield strength is called Bauschinger effect factor, BEF. A nonlinear strain hardening mathematical model is proposed for 7075 aluminium alloy (A7075). Uniaxial tension-compression experimental data are used to figure out a suitable model to study the BEF. Hence, uniaxial tension-co...
متن کاملModelling of Precipitation Hardening in Casting Aluminium Alloys
Precipitation hardening, because it involves the hardening of the material over a prolonged time, is also called age hardening, or ageing. By the appropriate heat treatment of precipitation hardening, the strength or hardness of some heat-treatable aluminium alloys can be enhanced by the formation of nano-meter sized second-phase precipitated particles within the original phase matrix. The fine...
متن کاملCreep of Aluminium and Aluminium Alloys
This chapter constitutes an introduction to creep and to the creep response of Aluminium and its alloys. Its major goals are: to provide basic information on creep and its mechanisms to give a description of the more extensively used mathematical relations among creep variables (time, stress and temperature) to illustrate the creep response of pure Aluminium and of Al-Mg alloys to provide a syn...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indian Journal of Science and Technology
سال: 2016
ISSN: 0974-6846,0974-5645
DOI: 10.17485/ijst/2015/v8i20/83960