Enhanced functionality of cantilever based mass sensors using higher modes

Mass determination and sensitivity based on resonance frequency changes of the higher flexural modes of cantilever sensors.

Micro- and nanocantilevers are increasingly employed as mass sensors. Most studies consider the first flexural mode and adsorbed masses that are either discretely attached or homogeneously distributed along the entire length of the cantilever. We derive general expressions that allow for the determination of the total attached mass with any mass distribution along the cantilever length and all ...

Position and mass determination of multiple particles using cantilever based mass sensors

Fabrication of cantilever based mass sensors integrated with CMOS using direct write laser lithography on resist

A CMOS compatible direct write laser lithography technique has been developed for cantilever fabrication on pre-fabricated standard CMOS. We have developed cantilever based sensors for mass measurements in vacuum and air. The cantilever is actuated into lateral vibration by electrostatic excitation and the resonant frequency is detected by capacitive readout. The device is integrated on standar...

Mass and position determination of attached particles on cantilever based mass sensors.

An analytical expression relating mass and position of a particle attached on a cantilever to the resulting change in cantilever resonant frequency is derived. Theoretically, the position and mass of the attached particle can be deduced by combining measured resonant frequencies of several bending modes. This finding is verified experimentally using a microscale cantilever with and without an a...

Analysis of Mass Based Micro Cantilever Using Comsol

--MEMS based mass sensors are being designed to identify the small amounts of materials especially for monitoring the food supply. The Fabrication of MEMS includes deposition of material layers, pattering by photolithography and etching to produce the required shapes, consequently leading to time taking and expensive method. In order to reduce the working time of sensor to market a Finite eleme...