Enhanced mechanics in injection molded isotactic polypropylene/polypropylene random copolymer blends via introducing network-like crystal structure
نویسندگان
چکیده
منابع مشابه
Influence of the temperature on flow-induced crystallization of isotactic polypropylene and propylene-ethylene random copolymer
BOITOUT, Hugo, "Influence of the temperature on flow-induced crystallization of isotactic polypropylene and propylene-ethylene random copolymer" (2014). Influence of the temperature on flow-induced crystallization of isotactic polypropylene and propylene-ethylene random copolymer Influence of the temperature on flow-induced crystallization of isotactic polypropylene and propylene-ethylene rando...
متن کاملEncoding Hydrogel Mechanics via Network Cross-Linking Structure
The effects of mechanical cues on cell behaviors in 3D remain difficult to characterize as the ability to tune hydrogel mechanics often requires changes in the polymer density, potentially altering the material's biochemical and physical characteristics. Additionally, with most PEG diacrylate (PEGDA) hydrogels, forming materials with compressive moduli less than ∼10 kPa has been virtually impos...
متن کاملInjection Molded Millimeter-Wave Horn Array Antenna
This paper shows injection molded millimeter-wave horn array antenna for the 1-dimensional APAA(Active Phase Array Antenna). The antenna is composed of horn antennas, grooved circular waveguide polarizers, E-plane T-junctions, and E-plane bends employing dielectric waveguides. This structure makes it possible to manufacture a feed circuit and radiating elements as an integrated unit by using in...
متن کاملThermal Processing of Injection-Molded Silicon Carbide
Silicon carbide is the most important and versatile non-oxide ceramic. Powder injection molding (PIM) is a method of high-speed fabrication of complex near-net shapes of SiC and other powders. Green micro-machining (GMM) is used to extend the shaping capability of green ceramics and powder metallurgy to smaller feature sizes. Debinding—removal of organic additives—is the rate-limiting step in P...
متن کاملInjection molded microfluidic chips featuring integrated interconnects.
An injection molding process for the fabrication of disposable plastic microfluidic chips with a cycle time of 2 min has been designed, developed, and implemented. Of the sixteen commercially available grades of cyclo-olefin copolymer (COC) that were screened for autofluorescence and transparency to ultraviolet (UV) light, Topas 8007 x 10 was identified as the most suitable for production. A ro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chinese Journal of Polymer Science
سال: 2015
ISSN: 0256-7679,1439-6203
DOI: 10.1007/s10118-016-1747-y