Enhanced Sensitivity of SAW-Based Pirani Vacuum Pressure Sensor
نویسندگان
چکیده
منابع مشابه
Pirani Pressure Sensor with Distributed Temperature Sensing
A Pirani pressure sensor is based on the fact that the thermal conductivity of a gas is dependent on the pressure. The structure presented in this paper consists of a heated microbeam, which is placed above a v-groove in a heat sink. The temperature distribution along the microbeam is a measure for the thermal conductivity of the surrounding gas. Measuring the temperature distribution instead o...
متن کاملModeling of capacitance and sensitivity of a MEMS pressure sensor
In this paper modeling of capacitance and sensitivity for MEMS capacitive pressure sensor is presented. In capacitive sensor the sensitivity is proportional to deflection and capacitance changes versus pressure. Therefore first the diaphragm displacement, capacitance and sensitivity of sensor with square diaphragm have been modeled and then simulated using finite element method (FEM). It can b...
متن کاملSensitivity Improvement of Wireless Pressure Sensor by Incorporating a Saw Reflective Delay Line
this paper presents a wireless surface acoustic wave (SAW) pressure sensor on 41YX LiNbO3 for tire pressure monitoring system (TPMS) application, in which a reflective delay line composed of an interdigital transducer (IDT) and several reflectors was used as the sensor element. Using the coupling of modes (COM), the SAW reflective delay line was simulated, and the optimal design parameters were...
متن کاملSAW Humidity Sensor Sensitivity Enhancement via Electrospraying of Silver Nanowires
In this research, we investigated the influence of the surface coatings of silver nanowires on the sensitivity of surface acoustic wave (SAW) humidity sensors. Silver nanowires, with poly(vinylpyrrolidone) (PVP), which is a hydrophilic capping agent, were chemically synthesized, with an average length of 15 µm and an average diameter of 60 nm. Humidity sensors, with 433 MHz frequency dual-port ...
متن کاملTire Pressure Measurement Using a Saw Hybrid Sensor
A tire pressure measuring system based on surface acoustic wave (SAW) sensors is presented. Since SAW sensors are powered by the energy of the RF field no battery is required, which is a major drawback of conventional systems. A successful combination of a SAW reflective delay line with a capacitive pressure sensor is shown. With a new way of matching the sensor impedance to the SAW reflector i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Sensors Journal
سال: 2011
ISSN: 1530-437X,1558-1748
DOI: 10.1109/jsen.2010.2086055