Enriching of Ti in Al-Ti alloys by aluminium monochloride
نویسندگان
چکیده
منابع مشابه
DIFFICULTIES IN GRAIN REFINING ALUMINUM LITHIUM ALLOYS USING COMMERCIAL Al-Ti AND Al-Ti-Bor MASTER ALLOYS
High strength aluminum alloys, especially those containing zirconium, are historically difficult to grain refine. Early efforts by Alcoa indicated that the addition of lithium to these alloys increases difficulty with grain refinement. Although grain refining of alloys 2090 and 2091 was possible, consistent results were not obtained. Statistically-designed experiments were used to quickly ident...
متن کاملPartitioning of solutes in multiphase Ti–Al alloys
First-principles calculations based on a plane-wave pseudopotential method, as implemented in the VASP code, are presented for the formation energies of several transition-metal and non-transition-metal dopants in Ti–Al alloys. Substitution for either Ti or Al in g-TiAl, a2-Ti3Al, Ti2AlC, and Ti3AlC are considered. Calculated szero-temperatured defect formation energies exhibit clear trends as ...
متن کاملCorrosion Characteristics of a - Ti and Ti 2 Cu Composing Ti - Cu Alloys
A series ef binary Ti-Cu alloys containing 5-20 mass% Cu was prepared, and the corresien behavior of a-Ti and Ti2Cu composing the Ti-Cu alloys were examined based on the anodic polarization curves and released iens in O.9% NaCl and 1% lactic acid solutions. In both selutions, the Ti-Cu alloys showed the same anodic polarization curves as titanium in the conditien below 1.4 V. Hewever, precipita...
متن کاملMechanical Alloys in The Al-rich Part of the Al-Ti Binary System
Aluminum is commonly used as fuel additive for propellants, incendiaries, and explosives. The main limitation to its use lies in comparatively slow ignition and oxidation/combustion kinetics. Performance can be significantly improved if pure aluminum is substituted by thermodynamically less stable alloys. In this context, mechanical alloys in the aluminum-rich section of the Al-Ti binary system...
متن کاملNucleation and Precipitation Strengthening in Dilute Al-Ti and Al-Zr Alloys
Two conventionally solidified Al-0.2Ti alloys (with 0.18 and 0.22 at. pct Ti) exhibit no hardening after aging up to 3200 hours at 375 C or 425 C. This is due to the absence of Al3Ti precipitation, as confirmed by electron microscopy and electrical conductivity measurements. By contrast, an Al-0.2Zr alloy (with 0.19 at. pct Zr) displays strong age hardening at both temperatures due to precipita...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1957
ISSN: 0451-5994
DOI: 10.2464/jilm.7.5_5