Environmental Testing of Airborne Electronic Components at High Sound Intensities
نویسندگان
چکیده
منابع مشابه
Transient lumanopia at high intensities
Transient lumanopia is the loss of sensitivity to a flicker burst presented in early dark adaptation. We earlier reported that lumanopia with 18 Hz flicker was greatest after turning off 400 td adapting fields and progressively disappeared as the adapting field was intensified. We now report that lumanopia can occur with intense adapting fields, but only with faster flickers (e.g. 40 Hz, 5000 t...
متن کاملEnhancement models at high light intensities.
The separate package and spillover models of photosynthetic enhancement are generalized and extended to light saturation assuming hyperbolic or exponential rate versus intensity curves. The available data are more consistent with the exponential model at high light intensities. Two significant conclusions follow: (a) the decreases in enhancement observed at high light intensities are accounted ...
متن کاملLarge quadrature squeezing at high intensities.
The squeezing properties of a system characterized by large y and y nonlinear susceptibilities and injected classical fields for the two relevant modes are studied as a function of the output power. A large reduction of noise levels well above threshold has been found and a remarkable dependence of the maximum squeezing on the input power has been shown. The possibility of an implementation wit...
متن کاملModel-Based Testing of Environmental Conformance of Components
In component-based development, the correctness of a system depends on the correctness of the individual components and on their interactions. Model-based testing is a way of checking the correctness of a component by means of executing test cases that are systematically generated from a model of the component. This model should include the behaviour of how the component can be invoked, as well...
متن کاملRapid Ir Heating of Electronic Components in the Testing Cycle
Electronic devices are often tested at elevated temperature after they are manufactured. The time required for testing can be reduced by increasing the rate of heating from ambient to test temperature, particularly if the devices are not removed from their factory carrier trays. This paper describes a new rapid-heating method based on low-cost infrared heaters. A basic model is developed to eva...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Acoustical Society of America
سال: 1954
ISSN: 0001-4966
DOI: 10.1121/1.1927948