Erratum: D.C. Amplifier for Biological Application
نویسندگان
چکیده
منابع مشابه
Two-Phase DC-DC Buck Converter for Power Amplifier Modulation
This thesis presents the theory, design, layout and a proposal for measurement set up of a synchronous DC-DC buck converter. This converter will be used as the supply modulator of power amplifier of mobile phones. The design is done using 45nm CMOS technology. Pmos and nmos switches are synchronously turns on and off for DC voltage conversion. Second order LC type filter is used to filter out t...
متن کاملA DC-coupled RF Amplifier in CMOS with DC-feedback
A CMOS multistage RF amplifier with DC coupling is presented. A complete optimisation of the various stages is done to maximize the RF gain for a given power budget. To decrease the effects of offsets and tolerances in high gain multistage amplifiers usually (lossy) AC coupling is used. The presented circuit employs DC coupling and DC control circuitry to avoid coupling-induced losses. Compared...
متن کاملOperational Amplifier Topologies and DC Specifications
Operational amplifiers (op amps) are as prolific in analog circuits as salt and pepper is on food. They are sprinkled throughout the sensor data acquisition system, performing a variety of functions. For instance, at the sensor interface, amplifiers are used to buffer and gain the sensor output. The current or voltage excitation to the sensor, quite often is generated by an amplifier circuit. F...
متن کاملHybrid Dc Accurate Charge Amplifier for Linear Piezoelectric Positioning
Piezoelectric transducers are known to exhibit less hysterisis when driven with current or charge rather than voltage. Despite this advantage, such methods have found little practical application due to the poor low frequency response of present current and charge driver designs. This paper introduces a new circuit topology free from low-frequency drift and DC load offsets. The hybrid load feed...
متن کاملLow flicker-noise DC amplifier for 50 Ω sources
This article analyzes the design of a low-noise amplifier intended as the input front-end for the measurement of the low-frequency components (below 10 Hz) of a 50 Ω source. Low residual flicker is the main desired performance. This feature can only be appreciated if white noise is sufficiently low, and if an appropriate design ensures dc stability. An optimal solution is proposed, in which the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Review of Scientific Instruments
سال: 1950
ISSN: 0034-6748,1089-7623
DOI: 10.1063/1.1745459