Evaluation of dynamic fracture-initiation toughness using a novel impact bend test procedure.
نویسندگان
چکیده
منابع مشابه
A NOVEL PROCEDURE FOR MEASURING THE IMPACT FRACTURE TOUGHNESS KId WITH PRECRACKED CHARPY SPECIMENS
A procedure i s presented f o r determining the impact f r a c t u r e toughness K w i t h precracked Charpy specimens wi thout performing any load measurements.'?he Kid-val ue i s obtained from preestabl ished impact response curves and a measurement o f t h e t ime-to-fracture. The measuring technique i s f u l l y dynamic and does not impose any r e s t r i c t i o n s on t h e t e s t condi...
متن کاملFracture toughness of dental composites determined using the short-rod fracture toughness test.
Plane strain fracture toughness (KIC) has been evaluated for a number of commercially-available dental composites. A modified Short-rod Fracture Toughness (SRFT) specimen design has been used, enabling small specimens to be tested conveniently. The effect on KIC of aging in water at 37 degrees C for seven days, one month, and six months has been determined for conventional, microfilled, and hyb...
متن کاملDynamic Fracture Initiation Toughness of a Gamma (Met-PX) Titanium Aluminide at Elevated Temperatures
Recently, a new generation of titanium aluminide alloy named Gamma-Met PX (GKSS, Geesthacht, Germany) has been developed with better rolling and postrolling characteristics. Previous work on this alloy has shown the material to have higher strengths at room and elevated temperatures when compared with other gamma titanium aluminides. In particular, this new alloy has shown increased ductility a...
متن کاملInfluence of Crack Length on the Measurement of Mode II Initiation Fracture Toughness of Wood by Three-Point Bend End-Notched Flexure (3ENF) Test
The mode II initiation fracture toughness of wood was measured by the three-point bend endnotched flexure (3ENF) test for various crack lengths, and the dependence of toughness on the crack length was analyzed by the four conventional methods of data reduction : elementary beam theory, Williams end correction method, and two compliance calibration methods. In addition to these methods, the comp...
متن کاملComparison of three real time techniques for the measurement of dynamic fracture initiation toughness in metals
Three techniques for measuring dynamic stress intensity factor time histories of dynamically loaded stationary modeI cracks are compared as applied to dynamically loaded pre-cracked 6Al–4V titanium alloy specimens. The three techniques are crack opening displacement (COD), dynamic strain gage measurement, and coherent gradient sensing (CGS). The stress intensity factor histories are inferred fr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1990
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.39.1637