Evaluation of Fatigue Crack Growth Characteristics of Whisker-Reinforced Aluminium Alloy Matrix Composite
نویسندگان
چکیده
منابع مشابه
Fatigue crack growth resistance in SiC particulate and whisker reinforced P/M 2124 aluminum matrix composites
Fatigue crack growth is examined in P/M 2124 aluminum alloys reinforced with SiC particles (SiCp) and whiskers (SiCw) over a wide spectrum of growth rates from 10 to 10 m per cycle. Effects of aging treatment, orientation of crack growth direction with respect to the rolling direction, mean stress (or stress ratio), and reinforcement volume percent on the fatigue crack growth threshold are inve...
متن کاملComposite Patch Repair of Central Crack Growth in Aluminium Alloy Plate
In this work, repaired crack in 6061T6 aluminum plate with composite patches presented, firstly we determine the displacement, strain and stress, also the first six mode shape of the plate, secondly we took the same model adding central crack initiation, which is located in the center of the plate, its seize vary from 20 mm to 60 mm and we compare the first results with second. Thirdly we repai...
متن کاملMechanical Characteristics on Fatigue Crack Propagation in Aluminium Plate
This paper present a mechanical characteristics on fatigue crack propagation in Aluminium Plate based on strain and stress distribution using the abaqus software. The changes in shear strain and stress distribution during the fatigue cycle with crack growth is identified. In progressive crack in the strain distribution and the stress is increase in the critical zone. Numerical Modal analysis of...
متن کاملFatigue Crack Growth in a Particulate TiB2-Reinforced Powder Metallurgy Iron-Based Composite
Fatigue crack growth behavior has been examined in a particulate titanium diboride (TiB2)–reinforced iron-based composite that had been produced via a mechanical alloying process. Comparison with equivalent unreinforced material indicated that fatigue crack growth resistance in the composite was superior to monolithic matrix material in the near-threshold regime. The composite exhibited relativ...
متن کاملTENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. 1, Solid mechanics, strength of materials
سال: 1991
ISSN: 0914-8809
DOI: 10.1299/jsmea1988.34.2_221