Evaluation of Mode I Fiber/Matrix Interfacial Fracture Toughness and Matrix Toughness in FRP by Using Real-Size Model Composites
نویسندگان
چکیده
منابع مشابه
Prediction of Mode II of Fracture Toughness in Laminate Composites
In this paper, effects of ply orientation of adjacent plies with (ϕ//θ) interfaces on mode II critical strain energy release rate (fracture toughness) of multidirectional (MD) laminate has been studied. Ply orientation of adjacent plies is one of the most important parameters affects the mode II critical strain energy release rate () in the initiation of the delamination. To study this paramet...
متن کاملMode I Interlaminar Fracture Toughness of Unidirectional Fiber-Reinforced Polymer Matrix Composites
1.1 This test method describes the determination of the opening Mode I interlaminar fracture toughness, GIc, of continuous fiber-reinforced composite materials using the double cantilever beam (DCB) specimen (Fig. 1). 1.2 This test method is limited to use with composites consisting of unidirectional carbon fiber and glass fiber tape laminates with brittle and tough single-phase polymer matrice...
متن کاملFracture toughness of dental composites determined using the short-rod fracture toughness test.
Plane strain fracture toughness (KIC) has been evaluated for a number of commercially-available dental composites. A modified Short-rod Fracture Toughness (SRFT) specimen design has been used, enabling small specimens to be tested conveniently. The effect on KIC of aging in water at 37 degrees C for seven days, one month, and six months has been determined for conventional, microfilled, and hyb...
متن کاملEffect of Rock Fracture Filling on Mode I and II Fracture Toughness
This paper focuses on some fracture toughness tests performed on the pre-cracked Brazilian specimens of rock-like materials. Also the effect of rock fracture filling on the fracture toughness was considered experimentally. Fracture toughness is a key parameter for studying the crack propagation and fragmentation processes in rock structures. Fracture mechanics is an applicable tool to improve ...
متن کاملInterfacial fracture toughness of Pb-free solders
Increasing environmental concerns and pending government regulations have pressured microelectronic manufacturers to find suitable alternatives to Pb-bearing solders traditionally used in electronics packaging. Over recent years, Sn-rich solders have received significant attention as suitable replacements for Pbbearing solders. Understanding the behavior of intermetallics in Sn-rich solders is ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 2011
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.77.882