Evaluation of Nominal Contact Area and Contact Pressure Distribution in a Steel-Steel Interface by Means of Ultrasonic Techniques.
نویسندگان
چکیده
منابع مشابه
The roles of contact conformity, temperature and displacement amplitude on the lubricated fretting wear of a steel-on-steel contact
This paper investigates the effect of contact geometry, temperature and displacement amplitude on the fretting behaviour of an aero-turbo oil lubricated cylinder-on-flat contact. To be effective, the lubricant needed both to penetrate the contact and then offer protection. Lubricant penetration into the fretting contact is found to be controlled by two physical parameters, namely (i) the width ...
متن کاملEffect of Contact Pressure and Frequency on Contact Heat Transfer Between Exhaust Valve and its Seat
The hot gases produced by the internal combustion engines passes through the exhaust valve and causes high temperatures in the exhaust valve and its seat. To avoid damaging the exhaust valve, heat must be transferred from the valve to its seat during the contact they make at the opening and closing cycle. Heat transfer rate from the exhaust valve to its seat is a function of many factors. One o...
متن کاملDeveloped endplate geometry for uniform contact pressure distribution over PEMFC active area
Contact resistance among the components of a polymer exchange membrane fuel cell (PEMFC) has a crucial effect on cell performance. The geometry of the endplate plays an essential role in the contact pressure distribution over the membrane electrode assembly (MEA) and the amount of contact resistance between plates. In this work, the effects of endplate geometry on the contact pressure distribut...
متن کاملAir Coupled Ultrasonic Inspection of Steel Rubber Interface
This paper describes the investigation for the feasibility of inspection of steel-rocasin rubber specimen used in rocket motor for detection of debond by using air-coupled ultrasonic. A pair of high performance air-coupled transducers was used to generate and receive the high intensity ultrasonic pulses. Probes were placed at the opposite side of the specimen during inspection. It was shown tha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME International Journal Series C
سال: 2003
ISSN: 1344-7653,1347-538X
DOI: 10.1299/jsmec.46.297